AddonicsT E C H N O L O G I E SRuby Combo Hard DriveRCHDSAES & RCHDSAEUUser’s GuideVersion 1.0FCC Warning StatementThis equipment has been tested and found to comply with the limits for a class B digitaldevice pursuant to Part 15 of the FCC rules. These limits are designed to providereasonable protection against harmful interference in a residential installation. Thisequipment generates, uses and can radiate radio frequency energy. If not installed andused in accordance with the instructions, it may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in aparticular installation. If the equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment on and off, the useris encouraged to try and correct the interference by one or more of the followingsuggestions.Reorient or relocate the receiving antennaIncrease the distance between the equipment and the receiverConnect the equipment to a different power outlet other than the one where receiver isconnectedConsult a certified television or radio technicianEnclosure OverviewStep 1 Separate the top from the bottom cover of the drive enclosure byloosening the screw as shown on the photo.Step 2 Align the SATA connector in the 2.5” hard drive with the SATA connectoron the PCB.Step 3 Wrap the shock absorbers around the hard drive and PCB.shockabsorbersPCBtop cover2.5” SATAhard drivebottom coverswitch