Adema Saniclass Circle SW108324 Installation Instructions Manual
INSTALLATION INSTRUCTIONS FORIP44 ILLUMINATED MIRRORSBefore installing this product pay special attention to these instructions. It is recommendedthat this product is installed by a qualified electrician and current building regulations.These products can safely be fitted into Zone 2. See lighting regulations diagram.Prior to commencing work isolate the power supply cable at the fuse box.Check that there are no other concealed cables or pipe work in the intended installation area(check the entire area).The mirror is mounted on the wall by means of two fixing screws.Make sure that it is at the correct height and level. Using a suitable marker through the fixingholes mark the position of the holes on the wall.Using the correct size drill bit for the wall fixing (please note that for certain wall types i.e.plasterboard walls, the wall fixings supplied are not recommended) drill holes in the markedlocations. Place the rawl plugs into the holes. Feed the supply through the central rubbergrommet, position the back plate and secure using the correct fixings (the rubber washersprovided must be used to ensure no water can penetrate into the fitting).Connnect the supply cable to the connector block as shown in the wiring diagram. Ensure theconductors are fully inserted into the terminals and no loose wire strands are protruding. fullytighten the screws on the terminals making sure that the screw clamps onto the conductor andnot the insulation.Fix the mirror to the wall.Ensure that the correct type and wattage bulb are always used. (see Luminaire for details).1.2.3.4.5.6.7.8.Shelf fixing (selected models only).To fix glass shelf to mirror attach the metal support arms to the bottom of the mirror frame usingthe screws provided. (the rubber washer supplied must be used to ensure that IP44 ismaintained). Place the glass shelf and secure with the screws located underneath the metalsupport arm.Cleaning InstructionsIn order to maintain the quality finish of this product please do not use any abrasives or solventswhen cleaning this product. Use only a damp cloth for cleaning this product.Do not allow water to stand on any part of the mirror.Please clean any spillage that may affect the quality of the finish as described above. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine