Axis 213 Installing

Also see for AXIS 213: Installation guide Product instructions User manual Datasheet User manual

Contents

Axis 213 Installing Manual pdf 1 page image

1AXIS 213 - Installing the AXIS 213ENGLISHInstalling the AXIS 213Please observe the following before installing the AXIS 213 PTZ Network Camera.• This product is designed for indoor use or locations where it is protected from rain and moisture. Tooperate the camera in these conditions, use the outdoor housing accessories.• Do not use strong or abrasive detergents when cleaning the casing. Use a mild detergent and wipegently.• Never position the camera directly towards the sun or other bright objects. Whether the camera is in useor not, never aim it at the sun or other extremely bright objects.Connecting the HardwareBefore you beginIf the AXIS 213 is to be mounted in a position where it is difficult to access, it isrecommended that you set the IP address and get the camera up and running beforecompleting the hardware installation, i.e. skip step 1 below until the installation iscompletely verified.The AXIS 213 PTZ Network Camera is supplied with a bracket for ceiling mounting.1. Drill two holes in the ceiling andsecure the bracket with theappropriate screws according tothe ceiling material.2. Connect a standard RJ-45 networkcable to your AXIS 213 andconnect it to the network.3. Optionally, connect the ConnectionModule (not supplied) to thecamera.4. Connect the power cable.5. The hardware installation is nowcomplete, proceed to Installing ona Network, on page 2.Note: If the AXIS 213 is to be placed upright on a desktop, remove the four screws on the underside of theunit to remove the bracket. Place the adhesive plastic feet by the screw holes.