09/2005HANSGROHE PRODUCT SERVICESINGEL LEVER LAV MIXERRef. No.: 10100801InstallationStarckInstallation (1)Attention: The mixer must connected to angle valves with integrated filter.The mixer can not used together with a continuous flow water heater.1. Flush through the supply pipes.2. Place the mixer including the sealing washer in position on the basin.3. Slip the slide washer, washer and collar nut over the threaded base and tighten thecollar nut by hand.4. Tighten screws.5. Connect the connecting hose to the angle valves; cold right - hot left.6. Install the battery (please see Exchange battery)Large differences in pressure between the hot and cold water supply should be balanced.OperationThe water temperature is adjusted by the adjusting lever.swivel forward = hot water,swivel backward = cold water.Adjustment (2)This mixer have following feature:background fade-out with integrated range adjustment, that means the mixer is automati-cally adjusted on to the local conditions (washbasin, brightness, reflection) by the sensorymechanism.Exchange battery (3)The mixer operates with a 6 V Lithium-Battery(DL 223A). The working life of the battery is 2 years by extremely operation. Over nightthe current consumption is reduced by a economy mode.Push a small hexagon socket screw key into the hole at the backside of the mixer and pullthe cover upwards. Take care to the O-ring.Attention: After installing the battery, the mixer may not activated for 1 min because ofadjusting itself.Cleaning washbasin (4)Cover the infrared sensor by hand, after 4 s remove slowly the hand , the automaticwater stop is activated for 1 min.adjusting leverinfrared sensor withlight emitting diode(LED)cover1237 7/8"+3/8"coldhot