BARRON TRACE-LITE BLCSLED Installation Instructions Manual
  |
Mounting OptionsINSTALLATION INSTRUCTIONS800.533.3948 • www.barronltg.com1BLCSLED20070108 REV 1 - 08/17IMPORTANT SAFEGUARDSREAD AND FOLLOW ALL SAFETY INSTRUCTIONS.When using electrical equipment, basic safety precautions should always be followed including the following:• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.• Installation and servicing of this equipment should be performed by qualified service personnel only.• Ensure the electricity connections conform to the National Electrical Code and local regulations if applicable.• Do not mount near gas or electrical heaters.• Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering byunauthorized personnel.• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition. Anymodification or use of non-original components will void the warranty and product liability.• Do not use this equipment for other than intended use.SAVE THESE INSTRUCTIONS!B: Chain Mounting with V hookAttach customer supplied V-Hooks to each end of the luminaire base.Attach customer supplied chain to the V-hooks and mounting surface.C: Surface Mounting (Fig. C)Secure luminaire base to mounting surface by inserting suitable fasteners(provided by others) into the key hole slots on the top side of theluminaire housing, and attaching the fasteners to a mounting surface.D: T-Bar Clip Mounting (Fig. D)Attach T-Bar clips (provided by others) to the designated slots on the luminairehousing as shown in (Fig.1) Position the luminaire into the T-Bar ceiling grid andsecure the luminaire to grid.Connect incoming power to driver. Use the General Wiring Diagram on page 2 forreference.E: If electrical conduit is used to supply incoming power to the luminaire, remove wiringknock outs (Fig. E), and use appropriate fittings (provided by others) to attach conduitto the luminaire.F: If power is supplied through an outlet box, attach the enclosed outlet box covers(Fig. F) to the slots on the back of the luminaire to ensure that the outlet box is entirelycovered.HousingLED moduleLED DriverSafety CableLED Driver CoverLensA:Slot for surface mounting fastenersEnd CapB: Slot for V hook (used with chain mounting)C:D: Slot for T-Bar clip mountingE: Wiring KnockoutsF: Outlet box cover (2 pieces)Concealed outlet boxFBACEDOutlet box Cover |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine