BARRON Trace-Light RxA Installation Instructions Manual

BARRON Trace-Light RxA Installation Instructions Manual Manual pdf 1 page image

INSTALLATION INSTRUCTIONS800.533.3948 • www.barronltg.com1IMPORTANT SAFEGUARDSREAD AND FOLLOW ALL SAFETY INSTRUCTIONS.When using electrical equipment, basic safety precautions should always be followed including the following:• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.• Installation and servicing of this equipment should be performed by qualified service personnel only.• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations if applicable.• Do not mount near gas or electrical heaters.• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering byunauthorized personnel.• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.• Any modification or use of non-original components will void the warranty and product liability.• Do not use this equipment for other than intended use.SAVE THESE INSTRUCTIONS!20070135 REV 4 - 02/19R Ax3.46in6.96in1.26in1.26inØ 0.55in0.98in0.55inArm Mount - Drilling patternPole Mount Arm1. Remove the side plate from the arm. Skip to step 3if mounting onto the square pole.2. Attach round pole mounting plate onto the arm.3. Route the cord through the arm, attach the fixture andthen tighten bottom screws.4. Slightly pull the wires to make sure the hole on thearm is sealed with a silicon gasket.5. Make wiring connections inside arm. Refer to theWiring section.6. Replace side plate ensuring the gasket is seatedcorrectly and fasten with screws.Fig. 1

/ 2

Related manuals for BARRON Trace-Light RxA