Balanced Audio Technology Phono Module Instructions Manual

Phono ModuleDear Customer,Your unit is equipped with an internal Phono Module. This option allows you to usea wide range of phono cartridges directly with the unit.The phono module can be configured for either High or Low gain setting. Thecorresponding phono gains will be 58dB and 44dB. Your unit is preset at the factoryto High gain position. To change the Gain setting, do the following:1. Turn the unit OFF and remove the top cover.2. Locate the Gain switch on top of the phono module PC board. This board islocated vertically near the back of the unit.3. Put the switch in the desired position (Left for Low gain and Right for High).4. Install the top cover and turn the unit ON.The default cartridge loading resistance value for the phono module is fixed at 47k.There is a provision for different cartridge loading on the PC board. Any desiredvalue loading resistors can be installed in the LOAD-L and LOAD-R locations (to theleft and right of the GAIN switch). These locations have female pins installed,allowing for a quick change of loading resistors. The male pins, supplied with theunit in an accessory kit, can be soldered to the loading resistors to make installationeasier.NOTE: Your unit comes equipped with RCA input shorting plugs installed into thePhono inputs. This minimizes the noise pick-up when there is no phono cartridgeconnected to the Phono input. Remove these plugs when connecting the phonocartridge cable to the unit input. Install them again every time you intend use theunit with no phono cable connected to it.1300 First State Blvd. Suite A W ilmington, DE 19804Tel: 302-999-8855 Fax: 302-999-8818

/ 1

Related manuals for Balanced Audio Technology Phono Module