Balboa Water Group VL260 Manual
Preparation and FillingFill the spa to its correct operating level. Be sure to open all valves andjets in the plumbing system before fi lling to allow as much air as pos-sible to escape from the plumbing and the control system during thefi lling process. When your spa is first actuated, it will go into Primingmode, indicated by “PR ” The Priming mode will last for less than5 minutes (press „Cool” or „Warm” to skip Priming Mode) and then thespa will begin to heat the spa and maintain the water temperature inthe Standard mode.ButtonsJETSPress the “Jets” button once to turn pump on or off, and to shiftbetween low and high speeds if equipped. If left running, the pumpwill turn off after a timeout period. The pump low speed timeout onsome systems may be as long as 4 hours. On non-circ systems, the lowspeed of pump 1 runs when the blower or any other pump is on. Itmay also activate for at least 1 minute every 30 minutes to detect thespa temperature (polling) and then to heat to the set temperature ifneeded, depending upon mode. When the low speed turns on auto-matically, it cannot be deactivated from the panel; however, the highspeed may be started.The last measured temperature is constantly displayed on the LCDscreen.Please note that the last measured water temperature only ap-pears exactly when the pump has run at least for 1 minute.To display the set temperature, press the Cool or Warmbutton once. To change the set temperature, press the button asecond time before the LCD stops fl ashing. Each press of the “Cool” or“Warm” button will continue to either lower or raise the set tempera-ture. After three seconds, the LCD will stop fl ashing and display thecurrent spa temperature.LIGHTPress the “Light” button to turn the light on and off. If left on,the light automatically turns off after 4 hours.MODEMode is changed by pressing the “Cool” or “Warm”button, then pressing the “Light” button.Standard Mode is programmed to maintain the desired tempe-rature. Note that the last measured spa temperature displayedis current only when the pump has been running for at least 2minutes. “St ” will be displayed momentarily when you switch intoStandard Mode.Economy Mode heats the spa to the set temperature only duringfi lter cycles. “Ec” will display solid when temperature is not current,and will alternate with temperature when temperature is current.Sleep Mode heats the spa to within 20°F/10°C of the set tempera-ture only during fi lter cycles. “Sl ” will display solid when tempe-rature is not current, and will alternate with temperature whentemperature is current.Preset Filter CyclesThe fi rst filter cycle begins 6 minutes after the spa is energized.The second filter cycle begins 12 hours later. Filter duration isprogrammable for 2, 4, 6, 8 hours or for continuous fi ltration(indicated by “FC ”). The default filter time is 2 hours.To program, press “Cool” or “Warm” then “Jets”Press “Cool” or “Warm” to adjust. Press “Jets” to exit programming.For more information, please, check the User Manual.VL260 CONTROLCOOL WARM – SET TEMPERATUREFill the spa to its correct operating level. Be sure to open all valves and |
Related manuals for Balboa Water Group VL260
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine