Baldor DC7 Instruction Manual
        |
MN908No. 282C Replaces 282BLB70131MN908Instruction Manual For Baldor Dust Control UnitsModels DC7, DC7–3, DC8, DC8–3, DC10, DC10–3, DC12, DC12–3 and DC14–3.For use on Grinders mounted to GA16 and GA20 pedestalsSAFETY NOTICE:WARNING statements describe conditions that may lead to personnel injury including potentiallyfatal injuries if the machine is not properly used and warnings are not properly followed.Caution statements describe conditions that may lead to equipment damage.Electrical shock can cause serious or fatal injury. Only qualified personnel should install,maintain or troubleshoot this equipment.WARNING: Do not operate this dust control unit until you are sure that you are completely familiarwith the safe operation of the dust control unit. Improper use can lead to severe injury.This manual defines proper use of this equipment. Before using this equipment for anyother use, please consult Baldor. Contact Baldor if you do not understand any procedureor operation concerning this dust control unit or this manual.WARNING: Do not use dust control unit in the presence of potentially combustible materials. Keep allcombustible materials and flammable vapors away from dust control unit.WARNING: Do not operate the dust control unit/grinder with the dust bag removed. Debris that maycome from an open exhaust outlet can be a hazard to nearby persons or equipment.WARNING: Prevent electrical shock hazard and accidental machine operation. Always disconnect dustcontrol unit from the power source before servicing, changing dust bag or maintenance.WARNING: Be sure the system is properly grounded before applying power. Do not apply power beforeyou ensure that grounds are connected. Electrical shock can cause serious or fatal injury.Follow the National Electrical Code (NEC) and local codes for the safe installation of thisequipment.WARNING: Always use safety glasses with side shields (or full face shield) when operating grinder.Do not use ordinary eyeglasses. Also use face or dust mask if cutting operation is dusty.WARNING: Don’t use in dangerous environment. Don’t use dust control units in damp or wetlocations, or expose them to rain. Electrical shock can cause serious or fatal injury.Follow the National Electrical Code (NEC) and local codes for the safe installation of thisequipment.WARNING: Unsuitable accessories or attachments added to this machine can create hazards. Baldoraccessories are specifically designed to be used with this grinder. Use accessories orattachments only in the proper intended manner. Accessories or attachments obtainedfrom another source may cause hazards. Consult the manufacturer before use.WARNING: Check damaged parts. Check for alignment of moving parts, binding of moving parts,breakage of parts, mounting, and any other conditions that may affect its operation.Damaged parts should be properly repaired or replaced.WARNING: Use proper extension cord. Make sure your extension cord is in good condition. When usingan extension cord, be sure it is rated for the voltage and current rating of your product. Anundersized cord will cause a drop in line voltage resulting in loss of power and overheating.Table 1 shows the correct wire size to use depending on cord length and nameplate ampererating. If in doubt, use the next heavier gauge. The smaller the AWG gauge number, the heavierthe cord.WARNING: Dust created during grinding, buffing, sawing, power sanding, drilling, and other activitiesmay contain chemicals known to the State of California to cause cancer, birth defects orother reproductive harm. |
manualsdatabase
Your AI-powered manual search engine