Balmar Max Charge MC-614-H Installation And Operation Manual

Also see for MAX CHARGE MC-614: Installation and operation manual Installation and operation manual Quick start guide

Balmar Max Charge MC-614-H Installation And Operation Manual Manual pdf 1 page image

1www.balmar.net / Customer Service: +1 (360) 435-6100 x1 / Technical Support: +1 (360) 435-6100 x3Tech Service is available Monday - Friday (8:30am - 7:30pm EST)INSTALLATION AND OPERATION MANUALIntroductionThe Balmar Max Charge MC-614 is the latest generation ofsmart, multi-stage Balmar Max Charge voltage regulators.Designed to provide precise voltage control for Balmar’shigh-output 12-volt alternators and other externally regulated P-typealternators, the MC-614 features user selectable programs for thefollowing battery types: Deep cycle flooded, standard flooded, gel,AGM, spiral wound AGM, and LiFePO4 batteries. The regulatoralso features a universal default program that’s designed for use invessels utilizing voltage sensitive halogen equipment.In addition to the user selectable preset programs, the MC-614features a wealth of advanced programming modes which make itpossible to tailor charging to a wide variety of environments.When used in conjunction with optional MC-TS-A andMC-TS-B alternator and battery temperature sensors, the MC-614features the ability to monitor and respond to a range of ambienttemperature conditions, including reduction or discontinuationof charging voltages, should a catastrophic over-temperaturecondition occur at the alternator or the batteries.Safety Considerations1. Always disconnect your battery banksand ensure that switches are “OFF” priorto installing your regulator.2. Remove loose-fitting clothing or jewelry,which could become entangled inyour motor or other machinery prior toinstalling regulator.3. Wear ANSI-approved safety eye-wearand protective gear.4. DO NOT attempt to modify the regulator.Modifications could result in damage toyour charging system, and will void yourwarranty.5. DO NOT attempt installation if you aretired or fatigued.6. Ensure that the engine has cooled beforeinitiating installation.7. DO NOT attempt regulator installationwhile using alcohol or medication thatcould impair your judgment or reactiontime.8. Always use the right tool for the job.Improper tool use may damage regulatoror your vessel, and could result inpersonal injury.9. Take time to read the manual. Equipmentdamage and possible injuries may resultfrom an incomplete understanding ofthe installation and operation of theMC-614 regulator. If you are unfamiliarwith marine electrical systems, consultwith a licensed marine electrician.MAX CHARGE MC-614MULTI-STAGEVOLTAGE REGULATOR©2017 Balmar LLC SUP-0201 REV.C 12/12/17Introduction 1 Basic Programming 10Safety Considerations 1 Adjust For Battery Type 10Regulator Installation 2 LiFePO4 11Unpacking Box 2 Belt Load Manager 12Locate/Mount Regulator 2 Display Mode 12Basic Wiring Installation 2 Alt. Failure Advisory 12Regulator Terminal Layout 3 Programming Flow Chart 13Installation By Wire 4-6 Adv. Programming 14-15Initial Start Up 6 Battery Equalization 16Regulator Operation 7 Default Program Settings 16Programming Display Modes 8 Add’l. Regulator Features 16Regulator Programming 10 Troubleshooting 17-18Using Magnetic Tool 10 Warranty 19Table of Contents