Band-it C002 JR Operating Instructions Manual

Band-it C002 JR Operating Instructions Manual Manual pdf 1 page image

BAND-IT-IDEX, Inc.A Unit of IDEX Corporation4799 Dahlia StreetDenver, CO 80216-3070 USAP: 1-800-525-0758F: 1-800-627-3925Document # P45087 rev. E© CopyrightBAND-IT-IDEX, Inc. 2002All rights reservedwww.BAND-IT-IDEX.comPage 1 of 3C002 JRHand ToolOperatingInstructionsNOTE: USE OF VISE IS OPTIONALPlace BAND-IT tool in vise. Insert Clamp in Tool andgrip end of band by Band Gripper Lever.Insert hose in clamp. Take up clamp by turning thehandle of BAND-IT TOOL clockwise. To feelmovement of band, place finger on BAND-IT BANDat buckle edge while tensioning with tool handle.When you no longer feel band moving throughbuckle, even as you turn handle, MAXIMUMPRESSURE IS EXERTED BY BAND-IT BAND, andyou should stop turning handle.Roll hose over approximately 30° BACKING OFFTENSION HANDLE ¼ to ½ turn only, through courseof rollover, depending on type and size of hose. Gripbuckle with hook in nose by pushing cutter handle.Push cutter handle farther to cut the band completingBAND-IT JR. Clamp.The finished BAND-IT JR. Clamp –To Install a BAND-IT Junior Clamp:1324

/ 3

Related manuals for Band-it C002 JR