WARNING . . . Not To Be Used for Personnel ProtectionNever use these products as sensing devices for personnel protection. Doing so could lead to serious injury or death.These sensors do NOT include the self-checking redundant circuitry necessary to allow their use in personnel safety applications. Asensor failure or malfunction can cause either an energized or de-energized sensor output condition. Consult your current BannerSafety Products catalog for safety products which meet OSHA, ANSI and IEC standards for personnel protection.Printed in USA 01/16 P/N 130426 Rev. DA-GAGE®EZ-ARRAY™Instruction ManualTwo-piece sensing array with 2 analog and 2 discrete outputs, plus serial outputFeaturesA cost-effective, two-piece measuring light curtain designed for•quick and simple installations with the sophistication to handlethe toughest sensing applicationsExcels at high-speed, precise process monitoring and inspection,•profiling, and web-guiding applicationsA comprehensive combination of scanning options:•– 14 measurement (“scan analysis”) modes– 3 scanning methods– Selectable beam blanking– Selectable continuous or gated scan initiation– Selectable threshold setting for semi-transparent applications– 2 analog outputs, 2 discrete outputs, plus Modbus 485-RTUserial outputOutstanding 4 meter range with 5 mm beam spacing•Available in 12 lengths from 150 mm to 2400 mm•Excellent 5 mm minimum object detection or 2.5 mm edge•resolution, depending on scanning methodReceiver user interface for quick, intuitive setup of many common•applications:– 6-position DIP switch for setting scan mode, measurementmode, analog slope, discrete output 2 option (complementarymeasurement or alarm operation)– 2 push buttons for gain method selection and alignment/blanking– 7 Zone LEDs for instant alignment and beam blockageinformation– 3-digit display for sensing information and diagnosticsSoftware PC interface available for advanced configuration setup•Remote teach wire option for alignment, gain settings, inverted•display, and DIP switch disable