Banner PSA-24 Specification Sheet
 |
PSA-24 Power Supplies (24 Volt)Printed in USA 05/01 P/N 67447PSA-24 Models86.4 mm(3.40")149.1 mm(5.87")1.8 m(6.0')50.8 mm(2.00")WARRANTY: Banner Engineering Corp. warrants its products to be free from defects for one year. Banner Engineering Corp. will repair or replace, free ofcharge, any product of its manufacture found to be defective at the time it is returned to the factory during the warranty period. This warranty does not coverdamage or liability for the improper application of Banner products. This warranty is in lieu of any other warranty either expressed or implied.Features• 24V dc power supply delivers up to 2.2 amps to power Banner 24V continuous LEDlights• Choose model with 120V ac North American power cord, or with 220V ac Europower cord• Includes pre-wired 9-pin D-sub connector for direct connection to LED lights• Tough ABS housingEnvironmental Rating IEC IP20; NEMA 1Operating Conditions Temperature: 0° to 50°C (+32° to 122°F)Maximum relative humidity: 95% at 40°C (non-condensing)Models InputInputCord OutputOutputCable Used withPSA-24E†PSA-24† 100-250V ac50/60 Hz1.0A (RMS) for 120V ac0.5 A (RMS) for 240V acNorth America(NEMA 5-15) 24V dc ±5%with voltageregulation of ±1%2.2 A max.1.8 m (6')Terminated with9-pin D-subconnector(female pins)ContinuousLED lightsCont. Europe(Schuko CEE 7)ConnectionsPin 6 = +VPin 7 = +VPin 8 = dc commonPin 9 = dc commonAccessory Extension CablesModels Length ConfigurationDB910† 3.0 m (10')DB906† 1.8 m (6') Terminated both ends with 9-pin D-sub connector, for continuous lights(one end male pins and opposite end female pins)DB9Y† 1.8 m (6') Y cable for powering 2 lights from one supply, for continuous lights† These models are not stocked and are non-returnable.Banner Engineering Corp., 9714 Tenth Ave. No., Mpls., MN 55441 • Ph: 763.544.3164 • www.bannerengineering.com • Email: sensors@bannerengineering.com |
Related manuals for Banner PSA-24
manualsdatabase
Your AI-powered manual search engine