Configurable Node with discrete inputs, discrete outputs, analog inputs, and analog outputsIP67 Base2.4 GHzIP20 Base900 MHzThe SureCross® wireless system is a radio frequency network with integrated I/O that can op-erate in most environments and eliminate the need for wiring runs. Wireless networks areformed around a Gateway, which acts as the wireless network master device, and one or moreNodes.• Wireless industrial I/O device with four selectable discrete inputs, four sourcing discrete out-puts, two 0 to 10V analog inputs, and two 0 to 10V analog outputs• 10 to 30V dc power input• DIP switches for user configuration• Frequency Hopping Spread Spectrum (FHSS) technology and Time Division Multiple Ac-cess (TDMA) control architecture ensure reliable data delivery within the unlicensed Indus-trial, Scientific, and Medical (ISM) band• Transceivers provide bidirectional communication between the Gateway and Node, includ-ing fully acknowledged data transmission• Lost RF links are detected and relevant outputs set to user-defined conditions• The DX80...C models are certified for use in Class I, Division 2, Group A, B, C, D; Zone 2(Category 3G) Hazardous Locations when properly installed in accordance with the Nation-al Electrical Code, the Canadian Electrical Code, or applicable local codes/regulations (seeSpecifications)For additional information, updated documentation, and accessories, refer to Banner Engineering's website, www.bannerengineer-ing.com/surecross.Models Frequency Environmental Rating I/ODX80N9X6S4P4V2V2 900 MHz ISM Band IP67, NEMA 6 Inputs: Four selectable discrete, two 0 to10V analogOutputs: Four sourcing discrete, two 0 to10V analogDX80N2X6S4P4V2V2 2.4 GHz ISM BandDX80N9X6S4P4V2V2C 900 MHz ISM Band IP20, NEMA 1Class I, Division 2, Group A, B, C, DHazardous Locations (see Specifica-tions)DX80N2X6S4P4V2V2C 2.4 GHz ISM BandInternal antenna models are also available, but are not UL Listed. For more information, contact your local Banner Engineering Corp.representative.WARNING: Not To Be Used for Personnel ProtectionNever use this device as a sensing device for personnel protection. Doing so could lead to seriousinjury or death. This device does not include the self-checking redundant circuitry necessary to allow itsuse in personnel safety applications. A sensor failure or malfunction can cause either an energized or de-energized sensor output condition.SureCross User Configuration ToolThe User Configuration Tool (UCT) offers an easy way to link I/O points in your wire-less network, view I/O register values graphically, and set system communication pa-rameters when a host system is not part of the wireless network.The UCT requires a special USB to RS-485 (model number BWA-UCT-900 for 1 Wattradios, BWA-HW-006 can be used for all other radios) converter cable to pass infor-mation between your computer and the Gateway. Download the most recent revi-sions of the UCT software from Banner Engineering's website: http://www.banneren-gineering.com/wireless.SureCross DX80 NodeP/N 134323 Rev. G 5/22/20130 134323 7