Bap IWR-220XR Operation Manual
Contents |
IWR-220XR Operation ManualCautions:Functions of Receiver IWR-220XRllllllDo not cover the infrared emitter area of the wireless microphone or thesurface of the infrared sensor, which may disturb the unit and causeabnormal operation.Since the unit uses infrared reflectance. Do not expose receive to the blackceiling or wall which may cause abnormal operation.Do not near the speaker which may cause howling.Do not drop and wet microphone.Do not replace the battery when power is on.Do not install the unit a location near heat source or in a place subject todirect sunlight, excessive dust, mechanical vibration or shock.Front Panel Rear Panel1.2.Green LED will light up accordingly when receives the infrared signalfrom microphone.3.Microphone output jacks that connect the mixed microphone output withcable provided to the amplifier.4.It changes the output level of the microphone. Set it to LINE whenconnecting the output jack to the AUX input of the amplifier or set it to MICwhen connecting the MIC jack of the amplifier.5.Connect to infrared external sensor.6.Press it down to turn on the receiver, the power indicator will light up.Press it again to turn off, the power indicator will go off accordingly.7.Supplies power to the unit.Power indicatorChannel indicatorMic outputs (A+B Mix)Mic/Line output level switchInfrared sensor inputsPower switchAC cordllllllFlat 04, 2/F., Yuen Fat Industrial Building,25 Wang Chiu Road, Kowloon Bay,Kowloon, Hong KongTel: (852)2571 8289 Fax: (852) 2571 0289Web site: www.bap.com.hkEmail: info@bap.com.hkBattery Charger (HC-10)OPERATION:1. Connect the DC plug of the adapter to the DCsocket of the charger.2. The indication lamp is red when charging.3. Press charge/discharge button once fordischarge (yellow) and press one more timethat will be back to charging status (red).4. When full charge, (green) and sounded.5. When connect the charging plug to the ringoutput socket of the charger, the rightcharger's trough could be an external charge.6. The full charge capacity is 700mAH.OPERATION:1. Connect the Adaptor to wall outlet.2. Insert the infrared wireless mic to thecharger.3. The red LED of charger will light upduring charging. Charging time will beapprox. 3.5 hours.4. When charging is completed, thegreen LED indicator will turn on andred LED turn off.Note: Be sure to use specified batteryonly. You can not charge othertype of battery. Do not use anybattery and battery charger otherthan specified.Handheld Mic Charger Holder (HC-20)Connection Diagram |
manualsdatabase
Your AI-powered manual search engine