Barronett Blinds SNAKE EYES Owner's Manual
  |
BarronettBlinds.comBarronettBlinds.com800-345-6007 • Fax (715) 822-4180E-mail: info@ardisam.comOwner's ManualBarronett Hub BlindsCheck for parts online at www.barronettblinds.com or call 800-345-6007 M-F 8-5 CSTWe at Barronett Blinds appreciate your purchase of one of our worldclass Hub Blinds. Follow these few simple instructions and your HubBlind will be sure to give you many years of trouble-free pleasure. In-structions should be kept safe and reviewed at least annually.If for any reason you have a problem with your product, DO NOT returnto the retailer; contact the Barronett Blinds customer service de-partment at 800-345-6007, Monday through Friday from 8 a.m.to 5 p.m., for assistance.SET-UP InSTrUcTIonS:1. Remove the ground blind frombackpack carrying bag.2. Lay the blind flat on the groundand be completely sure there isno material twisted or overlap-ping the ends of any poles.SEE fIgUrE 1.3. Grab the pull handle on theeyelet located in the center ofthe roof and pull upward so theroof portion pops open. SEEfIgUrE 2.4. Lift the roof up so that you cangrab any one of the hubs locatedin the center of each wall. Grabthe tie-down rope on the eyeletand pull out as you did in step 3.SEE fIgUrE 3.NOTE: Place your foot on theground skirt to help hold theblind in place when popping openthe walls. (Ground skirt is notincluded in all models).5. Proceed by walking aroundentire blind and pulling oneach of the wall’s tie-downropes to pop out each walluntil all sides are popped out.SEE fIgUrE 4 .6. Your blind should be standingup completely. You may nowproceed by anchoring the blindto the ground using the groundstakes and tie-down ropes pro-vided. Ground stakes for yourBarronett Blind are located in apouch inside of the blind. Thepouch is sewn in at ground levelonto the interior wall near thedoor. Anchor loops are sewn ineach corner and each side. Usethe provided tie-down ropesand tie free end to ground stake.SEE fIgUrE 5.NOTE: Window configurations can now be set. Native brushcan be placed in brush holders located around the blind. (Brushholders not included on all models.)ASSEMBLY AND USE INSTRUCTIONSFOR THE FOLLOWING MODELS:SNAKE EYES (SE250BA, SE250BW, SE350BA, SE350BW)GROUNDER (GR150BT, GR250BT, GR350BT)BIG MIKE (BM275BT)warningrEAD, UnDErSTAnD AnD folloW All ASSEMBlY,InSPEcTIon, AnD USE InSTrUcTIonS ProVIDEDBEforE EAcH USE. fAIlUrE To folloW WArn-IngS AnD InSTrUcTIonS coUlD rESUlT In SErI-oUS InJUrY or DEATH.KnoW THE locATIon of EAcH HUnTEr In YoUrPArTY AT All TIMES AnD BE AWArE of AnYonE ElSE HUnTIng In THE ArEA To AVoID Ac-cIDEnTS.USE cAUTIon WHEn SETTIng UP. KEEP AWAYfroM BoDY AnD fAcE. KEEP clEAr of oTHErPEoPlE WHIlE SETTIng UP.THIS ProDUcT IS noT fIrEProof. THE fABrIcWIll BUrn If IT coMES InTo conTAcT WITH AnoPEn flAME or fUEl SoUrcE. no HEATEr oroPEn flAME SHoUlD BE USED InSIDE or nEArTHIS BlInD.nEVEr AlloW cHIlDrEn or ADUlTS To USElIgHTED cAnDlES, MATcHES, or oTHEr SoUrc-ES of fIrE nEAr THIS ProDUcT.nEVEr USE AnY DEVIcES THAT ProDUcE fUMESWHIlE InSIDE of BlInD. SUcH DEVIcES coUlDrESUlT In cArBon MonoXIDE PoISonIng, In-JUrY, or DEATH.WHEn gUn HUnTIng, YoU SHoUlD AlWAYS AT-TAcH THE BlAZE orAngE SAfETY cAP (noT In-clUDED) PArT no. AV180 To THE roof of BlInDfor ADDED SAfETY froM oTHEr HUnTErS.uv warningUlTrAVIolET lIgHT BrEAKS DoWn lIgHTWEIgHT fAB-rIc fIBErS. THE MATErIAl WIll fADE, loSE STrEngTHAnD EVEnTUAllY DISInTEgrATE If lEfT In ProlongEDSUnlIgHT. To EXTEnD THE lIfE of YoUr groUnDBlInD, AVoID lEAVIng IT oUT In DIrEcT SUnlIgHT forEXTEnDED PErIoDS of TIME. SET IT UP In A SHADY ArEAWHEnEVEr PoSSIBlE. fADIng or DIScolorIng ofBlInD IS noT coVErED UnDEr YoUr WArrAnTY.OMHUBSRev. 04/05/10© 2010 Ardisam, Inc.All Rights Reserved.FIGURE 1ROOFFIGURE 2ROOFFIGURE 3ROOFWALLFIGURE 4FIGURE 5 |
Related manuals for Barronett Blinds BIG MIKE
manualsdatabase
Your AI-powered manual search engine