Bastl Instruments Quattro Figaro Manual
  | |
Contents | 
)Quatro Figaro is a 4 channel VCA. Channels A, B, C ,D areorganized in columns. Each channel has a gain knob witha maximum gain of a little over 2.)Each CV input has an attenuator. The gain of the vca islinear to the control voltage on each channel. The finalcontrol voltage is the GAIN voltage + the attenuated CVIN voltage.)Internal routingInternal routing enables you to use the QF as a simpleand powerful panning tool. Two input pairs (A+B andC+D) are internally routed via the jack switches, whichenables you to quickly setup a panning situation.Because the internal routing is via the connectorswitches, you can use all the channels independently byplugging in cables which disconnect the internal routing.Also the INVERTED CV OUT of channel A is connected tothe switch at the CV IN of channel B (the same with Cand D), which means that the inverted CV is connectedto the CV input of signal B as long as there is no jackplugged into the signal jack of channel B.)For each CV there is an inverted output (not affected bythe attenuator).)the signal from channel A is routed to the switch at thesignal jack of channel B (the same with C and D), whichmeans that the signal from channel A is connected tochannel B as long as there is no jack plugged into thesignal jack of channel B.instructionQUATTRO FIGAROQuattro FigaroQUAD VCA CV INVERTOR & MIX OUTS)) ))) )))))))Signal input goes thru the the VCA and is outputed tosignal out with gain linear to the CV.)Mixed outputsThe mixed outputs enable you to use QF as a voltagecontrolled mixer or voltage controlled stereo panningmixer. There are outputs of signal A mixed with signalC, signal B mixed with signal D (note that these twooutputs are inverted), A+B+C+D mixed together and itsinverted version� 4 channel VCA� CV attenuator per channel� Gain knob per channel� each CV input has inverted CV output� mixed outputs-(A+C), -(B+D), A+B+C+D, -(A+B+C+D)� internally routed CVs and signals via connectorswitches (for easy panning / crossfading setup)� handmade in Brno, Czech republictechnical detailsfeatures� 10 HP� 35mm deep (skiff friendly)� current +12 < 40 mA , -12 < 35 mA� PTC fuse and diode protected 16 pin power connector |
Related manuals for Bastl Instruments Quattro Figaro
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine