Beghelli BBX-SE Instruction Manual

Beghelli BBX-SE Instruction Manual Manual pdf 1 page image

BBX-SEBBX-SE-HOBeghelli U.S.A., 3810 Executive Way, Miramar, Florida, Tel: (954) 442-66009/16/22One blink ON/pause (4 seconds) Battery is not connectedTwo blinks ON/pause (4 seconds) Battery is shorted or battery voltage drops below acceptable levelThree blinks ON/pause (4 seconds) Charger board circuit faultFour blinks ON/pause (4 seconds) Transfer circuit faultFive blinks ON/pause (4 seconds) Emergency lamp faultSix blinks ON/pause (4 seconds) Remote head’s emergency lamp fault (if installed)3. For manual test, press test button as follows:Press test button once (within 2 seconds) 30 seconds testPress test button twice (within 2 seconds) 3 minutes testPress test button 3 times (within 2 seconds) 30 minutes testPress test button 4 times (within 2 seconds) 90 minutes test1. Install the BBX/ BBX-HO according to the installation instructions.2. When AC power is supplied to fixture, the unit will automatically initiate a self-test with self-diagnostics that will do the following:(1) Monitor for faults with battery, charger board, lamps and transfer circuit every 5 seconds.(2) Perform a three-minute self-test every month.(3) Perform a 90-minute self-test every 12 months starting in the 12th month after installation.Note: ALL functions are factory pre-set (does not need field adjustment).3. Dual color LED lamp indicator shows the following status:(1) Green color: ON/ ReadyBlinking: Testing(2) Red color: Service AlertBlinking: Sequence below determines service requiredTO RESET:After resolving the fault of emergency equipment, press test button for 2 seconds without releasingto reset. LED indicator will show green.Page 1 of 2

/ 2

Related manuals for Beghelli BBX-SE