Beghelli Tempesta TA-RMT-LED Instructions Manual

Beghelli Tempesta TA-RMT-LED Instructions Manual Manual pdf 1 page image

INSTRUCTIONSIMPORTANT SAFEGUARDSWhen using electrical equipment, basic safety precautions should always be followed including the following:1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS2. Turn off power supply before attempting to install the unit3. Do not let power cords touch hot surfaces4. Do not mount near gas or electric heaters.5. Equipment should be mounted in locations and at heights where unauthorized personnel will not readily subject it totampering.6. The use of accessory equipment not recommended by Beluce Canada Inc., may cause an unsafe condition, and willvoid the unit’s warranty.7. Do not use this equipment for other than its intended purpose.8. Qualified service personnel should perform servicing of this equipment.9. Consult building code for approved wiring and installation10. The fixture must be grounded to avoid potential electric shock11. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) Thisdevice may not cause harmful interference, and (2) this device must accept any interference received, includinginterference that may cause undesired operation.12. SAVE THESE INSTRUCTIONS!INSTALLATIONNOTE: DC Polarity is critical yellow lead is positive and purple lead is negative. Reverse polarity connection willdamage LED boards and void warranty.1. Remove the lens by placing an appropriate sized flat head screw driver into the snap lock clips and pushing the clipsslightly in and down until they release the lens. This must be completed to each of the four clips (Figure 1).2. Pull the lens away from the unit. The internal reflector and chassis can now be removed by placing the screw driverinto the reflector locking channels and twisting slightly until the clip releases. This must be completed to each of thefour mounting channels (Figure 2). For recessed installation see (Figure 3)3. Pull the reflector and chassis away from the back plate.4. Bring the DC wires into the housing through the top or back knockout hole using a matched conduit fitting (supplied byothers).5. Surface, wall or ceiling installation can be completed by installing screws and washers (supplied by others) with awaterproof cap through the back of the fixture housing (Figure 4).6. Connect 12V or 24 VDC to yellow (positive +) and to purple (negative - ).7. Re-align the reflector with the back plate and push together until each locking clip engages (Figure 5).8. Align the lens with the unit and push in back into place until each lens snap lock clip engages.WALL MOUNTINGFixture is shipped with LED strips positioned for ceiling mounting. To improve light distribution for wall mounting(Figure 10) configure unit as follows:1. Test switch holes indicates bottom of fixture (Figure 6)2. Ensure locating pin goes through slot in LED strip (Figure 7)3. Un-snap bottom LED strip and gently snap into middle notch and lower notch (Figure 8)4. Un-snap top LED strip and gently snap into lower notch and upper notch (Figure 10)Tempesta™ LED Remote (TA-RMT-LED)926000332MAINTENANCE1. The equipment is to be repaired whenever the equipment fails to operate as intended during the duration test.Written records of test results and any repairs made must be maintained. Beluce Canada Inc. strongly recommendscompliance with all Code requirements.2. Clean lens on a regular basis.NOTE: The servicing of any parts should be performed by qualified service personnel only. The use of replacement partsnot furnished by Beluce Canada Inc., may cause equipment failure and will void the warranty.The LEDs listed herein when used according to the instructions with this unit are in accordance with the requirements ofCSA Standard C22.2, No. 141 – Unit Equipment for Emergency Lighting.Beluce Canada Inc., 3900 14th Avenue, Markham, ON L3R 4R3 Tel: (905) 948-9500 Fax: (905) 948-867306/09/2019

/ 2

Related manuals for Beghelli Tempesta TA-RMT-LED