Port Authority2™ USB 2.0 PCI Adapter Card 6-PortUser’s ManualUSB Port FeaturesCompliant with USB specification Revision 2.0- Compliant with EHCI specification Revision 1.0- Compliant with OHCI specification Revision 1.0- PCI multi-function device consists of two OHCI Host controllers for full/low-speed signaling and ECHI HostController core for high-speed signaling- 2 downstream facing ports in the root hub with integrated physical layer transceivers shared by OHCI andEHCI Host controllers- Supports PCI-Bus Power Management interface specification release 1.1- Legacy support for all downstream facing portsSystem Requirements• PCI-enabled computer system• CD-ROM drive (to install driver software, if needed)Package ContentsThis PCI USB Card package includes the following:• PCI USB Card• CD Driver• ManualSoftware:• Windows® 98SE/ME/2000/XP & MACConfiguration.The PCI USB CardThis section provides information on how to install drivers for the listed operating systems.Windows® 98SE/ME Driver Installation1. Run the driver installer program. (D:\Drivers\Windows\Driver.exe) – substitute D: for the letter of your CD-ROM.2. This program will copy driver files onto your windows system. Once completed, restart your computer.3. After system reboot, windows will find the new hardware “ALI PCI to USB Enhanced Host Controller” andinstall the driver.4. Restart the computer again to complete the installation.The ports are labeled as‘UJ1’,’UJ2’, for the USBconnectors, These ports arewhere you physicallyconnect your hardware(mouse, keyboard, etc).