The RBF SeriesMODELS:RBF101 (Supersedes Models RB101 & RB121)Features & Benefits■ Retrofits into model RBC wall can or usewith wall can model RBFC■ Primary and Secondary Thermal Safeguards• Robust, heavy duty high temperaturemanual power reset• Over-temperature one-time thermal fuse■ Nichrome element wrapped around micainsulators for durability■ Powder coat paint process eliminates sharpcutting edges■ Stainless steel grill and frame■ Convenient ON-OFF rocker switch control■ Two year extended warranty■ Factory tested and UL listedWARNINGTurn the electrical power off at the electricalpanel board (circuit breaker or fuse box) and lockor tag the panel board door to prevent someonefrom turning on power while you are working onthe heater. Failure to do so could result inserious electrical shock, burns, or possible death.SAVE THESE INSTRUCTIONS1. Read all instructions before using this heater.2. Read all information labels. Verify that the electrical supplywires are the same voltage as the heater.3. All electrical work and materials must comply with theNational Electric Code (NEC), the Occupational Safety andHealth Act (OSHA), and all state and local codes.4. Connect the grounding screw provided in the wall can to thesupply ground wire.5. If you need to install a new circuit or need additional wiringinformation, consult a qualified electrician.6. Protect electrical supply from kinks, sharp objects, oil,grease, hot surfaces or chemicals.7. WARNING!Overheating or fire may occur. DO NOT install the heater ina floor, ceiling, or behind doors.8. WARNING!Fire or explosion may occur. DO NOT install heater in anyarea where combustible vapors, gases, liquids, or excessivelint or dust are present.9. WARNING!Burn Hazard. This heater is hot when in use. To avoid burns,do not let bare skin touch hot surfaces. Use extreme cautionwhen any heater is used by or near children or invalids.10. WARNING!Risk of Electrical Shock. Connect grounding lead to groundingscrew provided. Keep all foreign objects out of heater.11. WARNING!Risk of Fire. Do not block heater. Heater must be kept clear ofall obstructions: a minimum of 3 feet in front, 6 inches aboveand on both sides. Heater must be kept clean of lint, dirt anddebris. (See Maintenance Instructions).12. Use this heater only as described in this manual. Any otheruse not recommended by the manufacturer may cause fire,electrical shock, or injury to persons.IMPORTANT INSTRUCTIONSOWNER’S GUIDEwww.cadetco.com Tel: 360-693-2505 P.O. Box 1675 Vancouver, WA 98668-1675TOOLS REQUIRED:• Phillips Screwdriver• Straight Screwdriver• Wire Strippers• Utility Knife• Insulated Wire Connectors