OWNER’S GUIDE FOR MULTI-WATT MODELSThe Com-Pak™ Bath Heater■ Primary and secondary thermalsafeguards•High temperature manual reset•Over temperature one-time thermaldevice■ Commercial grade steel element paintedto resist rusting■ Built-in controls• Single pole thermostat • 60 minute timer■ Powder coat paint process eliminatessharp cutting edges■ Three year extended warranty onelement and motor.■ Factory tested■ Multi-Watt•1300–800–500 at 240 Volt AC•975–600–375 at 208 Volt ACModels: The Com-Pak Bath Heater CBC132TW and CB132TFeatures & BenefitsSAVE THESE INSTRUCTIONSIMPORTANT INSTRUCTIONSTools Required:Phillips ScrewdriverStraight ScrewdriverWire StrippersUtility Knife4 11/2" Wood Screws3 Insulated Wire Connectors1 Strain Relief ConnectorWARNINGTurn the electrical power off at the electrical panelboard (circuit breaker or fuse box) and lock or tagthe panel board door to prevent someone fromturning on power while you are working on theheater. Failure to do so could result in seriouselectrical shock, burns, or possible death.1. Read all instructions before using this heater.2. Read all information labels. Verify that the electricalsupply wires are the same voltage as the heater.3. All electrical work and materials must comply with theNational Electric Code (NEC), the Occupational Safetyand Health Act (OSHA), and all state and local codes.4. Connect the grounding pigtail (copper wire) provided inthe wall can to the supply ground wire.5. If you need to install a new circuit or need additionalwiring information, consult a qualified electrician.6. Protect electrical supply from kinks, sharp objects, oil,grease, hot surfaces or chemicals.7. WARNINGOverheating or fire may occur. DO NOT install the heaterin a floor, in the ceiling, below a towel bar, behind a door,or anywhere the air discharge may be blocked in anymanner.8. WARNINGFire or explosion may occur. DO NOT install heater in anyarea where combustible vapors, gases, liquids, orexcessive lint or dust are present.9. WARNINGDO NOT install where heater is likely to get wet.10. WARNINGHeater must be connected to a GFCI protected branch circuit.11. WARNINGBurn Hazard. This heater is hot when in use. To avoid burns,do not let bare skin touch hot surfaces. Use extremecaution when any heater is used by or near children or invalids.12. WARNINGRisk of Electrical Shock. DO NOT install the heaterdirectly above bathtub or sink. DO NOT install in showerstall area (Manufacturer recommends a minimum 2 footclearance).13. WARNINGRisk of Electrical Shock. Connect grounding lead togrounding wire provided. Keep all foreign objects out ofheater.14. WARNINGRisk of Electrical Shock. Never place a switch where it canbe reached from the tub or shower enclosure.15. WARNINGRisk of Fire. Do not block heater. Heater must be kept clear ofall obstructions: a minimum of 3 feet in front, 6 inches aboveand on both sides. Heaters must be kept clean of lint, dirt anddebris. (See Maintenance Instructions).360-693-2505 Fax: 360-694-8668 P.O. Box 1675 Vancouver, WA 98668-1675The Com-Pak™ Bath Heater1/2” Depth10” Width12 5/8” Height