www.camsat-cctv.comWireless video and audio transmission systemfor 4 IP PoE cameras in the band 5.1 - 5.8 GHzQUICK STARTver. 1.1LINK INFORMATIONIt contains basic information about the settings of the radio module eg. thename of the radio link, signal strength and a list of connected radio transmitters.CAMERA CONNECTION SETTINGSWireless – Contains settings of radio link eg. transmission type (Master / Slave),the frequency of the operating channel, the name of the SSID link,signal strength, transmission coding.Network Settings – Contains settings of IP networks.1. Website panel menu treeTime Zone Setting - set the time, the NTP serverSystem Log - an overview of recent actions and changes in the CDS-6IPMultiUpgrade Firmware - Software UpdateBackup/Restore - save / restore configuration of systemADVANCED SETTINGS7. The recommended configuration settings:a) Change the password to log on to the web panel WWW(ADVANCED SETTINGS/PASSWORD)b) Enter the password of radio transmission encryption - a recommended codingWAP2-PSK (CAMERA CONNECTION SETTINGS/WIRELESS)c) Scan free channels – set the receiver at the operating mode SlaveSave and press Scan Masters to scan the busy channels.With this information, you will learn which channels in a given area are free or theleast busy. In the absence of available operating channels it is allowed to usemultiple radios on the same channel, then choose a channel of the weakest signal(below <-65dB)8. Testing the radio link.The last step is to check the correctness of transmission between devices.These steps must be repeated for each unit transmitting / receiving sequentiallyconnecting them to a computerEUEUPOLISHMARKPOLISHMARKPassword -14 Full instructions can be found at: http://camsat-cctv.com/cds-6ipmultiFull instructions can be found at: http://camsat-cctv.com/cds-6ipmultiThe last step is to check the correctness of transmission between devices.To check the status of connected devices CDS-6IPMulti such as power signal, connec-tion time, speed, IP address, etc. you must enter the LINK INFORMATION.To view an updated list of current connections, click the Refresh button at the bottomor press F5. The appearance of list of MAC addresses of broadcasting units in thereceiver indicates the correctness of the radio configuration. To be sure disconnectfrom the transmitting unit from computer and connect the IP camera.If the devices communicate with receiver it means that the radio connection isproperly configured and running. In the browser address bar enter the IP address ofthe camera and check the quality of image transmission. You can now assembly unitsat the facility.TECHNICALSUPPORTtel.+48 52 387 36 58Mon–Fr 8.00 AM–4.00 PMNOTE: Before first use, it is necessary to check the full user manualFull user manual can be found at: www.camsat-cctv.comchanging the password