Install the Ink TanksUnpack the Printer1 2 3 4 5Prepare the Printer Install the PrintheadColor Bubble Jet™ PrinterConnect the PrinterTo Your ComputerS500Start HereEasy Setup Instructions(IEEE 1284 compliant)Turn the printer off.Parallel CableFor USB Cables:For Parallel Cables:1Connect one end of the USB cableto the computer, the other to the printer.22Turn the printer off.1Connect one end of the parallel cable tothe computer, the other to the printer.IMPORTANT: Be sure printer is off before continuing, or the computer will attempt to install the printer driver before the printer is ready.IMPORTANT: Be sure printer is off before continuing, or the computer will attempt to install the printer driver before the printer is ready.Continue with Step 6on side two.USB PortUSB CableParallel PortSecureWire ClipsParallel Cable12Pull the orange tab off the yellow ink tank(BCI-3eY), then remove and discard theplastic wrapper.Twist off and discard the orange protective cap.NOTE: To avoid spilling ink, never press onthe sides of an ink tank.Insert the ink tank into the correct slot.(Refer to the color guide on the printhead.)Press down gently until the ink tank locksinto place.Insert the remaining three ink tanks intotheir assigned slots.34Close the front cover and attach thepaper rest and output tray.53Protective capElectrical contacts1Gently slide the printhead into the holder.The printhead will rest at a slight angle.Do not press it down.4Remove the printhead from its package.Turn the printhead over, then removethe orange protective cap.2NOTE: Do not touch the electrical contacts.5 Lower the lock lever and gently press it down until it locks into place.Raise the gray lock lever.Press the POWER button.1Shipping TapePOWERLightPOWERButtonProtective tapeSerial numberPlug the power cord into the back of the printer and connect the other end to a power outlet.23Open the front cover. The printhead holderautomatically moves to the center. Remove the protective orange tape.Write down the serial number located tothe right of the printhead. You will needthis later to register the product.54Ink TanksBCI-3eC Cyan BCI-3eM MagentaBCI-3eBK Black BCI-3eY YellowRemove the orange shipping tapefrom the front and sides of the printer.Carefully remove all items from the box.1Power CordS500 SeriesColor Bubble Jet PrinterDocumentation and Software KitS500 BJ (Bubble Jet) PrintheadPaper RestOutput Tray