ONE-Touch WIND BRACE12-VOLT AWNING INSTRUCTIONSTHE ONE-TOUCH WIND BRACES STORESEPARATELY AND ARE INTENDED TO BE USED INWINDY CONDITIONS. FOR YOUR BESTPROTECTION, IF YOU INTEND TO LEAVE YOURVEHICLE WITH THE AWNING OUT, IT ISALWAYS GOOD TO PUT THE WIND BRACES INTOPLACE. THE USE OF THE WIND BRACES ELIMI-NATES USING ANY WIND TIE DOWN STRAPS.FOLLOW THESE STEPS FOR PROPERINSTALLATION.STEP 1: PLACE THE SADDLE OF THE WINDBRACE UNDER THE PIVOTING AREA OF THEAWNING BRACES AS SHOW AT THE RIGHT.STEP 2. WITH THE BRACE POSITIONED AS SHOWNBELOW, SLIDE DOWNWARD UNTIL THE BRACEBOTTOMS OUT ON THE INSIDE OF THE ARM CHANNELAND MAKES CONTACT DOWN AGAINST THE TOP OFTHE ARM COVER AS SHOWN BELOW RIGHT. THESPRING IN THE WIND BRACE SHOULD BE AT LEASTSLIGHTLY COMPRESSED AT THIS POINT.SLIDE DOWNWARDWHILE HOLDING THESADDLE UNDER THEBRACE AS SHOWN.WIND BRACEBOTTOMED OUTAGAINST INSIDEOF ARM ANDRESTING DOWNAGAINST THE TOPOF ARM COVER.SPRING SHOULDBE AT LEASTSLIGHTLYCOMPRESSED ATTHIS POINT.STEP 3: TO OBTAIN PROPER TENSION ON THEWIND BRACE IT MAY BE NECESSARY TO ADJUSTTHE BRACE BY PUSHING INWARD ON THE SPRINGBUTTON AND LOCATING IT IN A DIFFERENT HOLE,EITHER DECREASING OR INCREASING THE OVER-ALL LENGTH OF THE BRACE. (SEE LOWER LEFT)PROPER ADJUSTMENT IS WHEN THE SPRING IS ATLEAST SLIGHTLY COMPRESSED WHEN THE BRACEIS IN THE POSITION AS SHOWN DIRECTLY BELOW.WIND BRACEADJUSTMENT HOLESAND SPRING BUTTON.SPRING1.2. 3.052943-001Manual Compliments ofNorthwest RV SupplyPrinted Fromhttp://www.nwrvsupply.com