Carrier 38AD Installation, Start-up And Service Instructions Manual

Also see for 38AD: Installation, Start-Up and Service Instructions Installation, Start-Up and Service Instructions Application data Manual

Carrier 38AD Installation, Start-up And Service Instructions Manual Manual pdf 1 page image

Condensing UnitsAir-Cooled — RemoteINSTALLATIONLifting Unit — Do not sling unskidded unit. Usespreader bars to prevent slings from damaging unitpanels. Do not roll unskidded unit on pipes orrollers.Skid Removal — Remove the 4 bolts holding topframe in place and lift frame from unit.Remove compressor compartment end panel.Raise and block up compressor end of unit about10 inches. Remove 4 bolts and nuts, 2 in endcorners and 2 where compressor and condensersections meet. Lower unit. Raise and blockopposite end. Remove remaining 2 bolts and nuts.Position Unit so air flow is unrestricted for at least2 ft on each side, 3 ft on each end, and for at least5 ft above unit top. See Fig. 1.Erect Unit using legs attached to unit base skid.Block up or suspend unit. Bolt leg to eachcorner of unit. Bolt 2 legs to bottom of unit wherecompressor and coil sections meet. Lower unit.Compressor Mounting — As shipped, compressor isheld tight by self-locking bolts.BEFORE STARTING UNIT - Loosen self-lockingbolts until the flanged washer is still snug but canbe moved sidewise. Do not remove shipping bolts.V KtGGiNG POINTS <4) HOLESLEGEND1 -3/8~>rs. ODE Suction Line Conn. 2-1/2-in. Oiaro Hote5/8-in. ODE Liquid Line Conn. 7/8-in. Diem Hote3/4-in. Thermostat Conn. 7/8-in. Diem HoteD — l-T/4-in. Electrical Conn. 1-3/4-in. DiarrrHoteE — 3/4-in. Fan Coil Control Wire Conn. 7/8-in. Diam HoleCertified dimension drawings are avaite&te on request.Fig. 1 — Physical Data and Dimensions© Carrier Corporation 1971 Form 38AD-4SI