Carrier 48SD User's Information Manual

Also see for 48SD: Owner's information manual Installation instructions

Carrier 48SD User's Information Manual Manual pdf 1 page image

48SDGas Heating/Electric Cooling UnitsVisit www.carrier.comUser's information ManualA Guide To Operating and MaintainingNEATING & COOLINGNOTE: Read the entire instruction manual before starting theinstallation.SAFETY CONSIDERATIONSNote to Installer: This manual should be left with the equipmentuser.FIRE and EXPLOSION HAZARDFailure to follow thiw warning could result in personal injury,death and/or property damage.Do not store or use gasoline or other flammable vapors andliquids in the vicinity of this or any other appliance.FIRE, EXPLOSION, ELECTRICAL SHOCK HAZARDFailure to follow this warning could result in personal injury,death and/or property damage.Do not use this unit if any part has been under water.Immediately call a qualified service technician to inspect theunit and to replace any part of the control system which hasbeen under water.For your safety if you smell gas:1. Do not try to light any appliance.2. Do not touch any electrical switch: do not use any phone inyour building.3. Immediately call your gas supplier from a nearby phone.Follow the gas supplier's instructions.4. If you cannot reach your gas supplier, call the firedepartment.I , = TELECTRICAL SHOCK HAZARDFailure to follow this warning could result in personal injuryand/or death.Before performing recommended maintenance, be sure themain power switch to unit is turned off and lock-out taginstalled.UNIT INTRODUCTIONThis 48SD unit is a small packaged gas heat/electric coolingsystem that can provide year-round comfort.Starting or Shutting Unit OFFNOTE: Your combination heating/cooling unit is equipped withan automatic direct spark ignition and power combustion blower.A99338Fig, 1-Gas Heating/Electric Cooling UnitTO START (LIGHT) UNIT:FIRE and EXPLOSION HAZARDFailure to follow this warning could result in personal injury,death and/or property damage.Do not attempt to light by hand.FIRE, EXPLOSION, ELECTRICAL SHOCK HAZARDFailure to follow this hazard warning could result in personalinjury, death and/or property damage.1. Do not turn off the electrical power to unit without firstturning off the gas supply.2. Before attempting to start the gas heating section, famil-iarize yourself with all the procedures that must befollowed.Refer to Fig. 2 for location of unit access panel. Refer to Fig. 3 forlocation of gas valve. Refer to Fig. 4 while proceeding with thefollowing steps.1. Set the temperature selector on room thermostat to the lowesttemperature setting and set system switch to HEAT.2. (;lose the external manual gas shutoff valve.3. Turn off the electrical supply to the unit.4. Remove the front access panel with a 5/I6-in. nut driver.5. Move the selector switch on the internal gas valve to the OFFposition and wait 5 minutes.6. Move the selector switch on the internal gas valve to the ONposition.Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.Book 1h_h__ PC 101 Printed in U.S.A. Catalog No. OM48-29 Pg 1 02-07 Replaces: OM48-20Tab Ilal 6a