Cateye ViZ300 Manual
Also see for TL-LD810: Manual
USBUSBBracket rubber padLight unit USB cable(MICRO USB)Bracket(SP-15)Ladder rubber bandIncluded Items BA CSwitchCAUTION!:• Always charge the product before use.• Once charging is completed, securely close the charging port cover.To PC or USB battery chargerUSB cableCharging port cover Standard charging timeOff Charging is completedSteady red light ChargingIndicatorAutomatic battery-saving function:When the remaining battery power gets low, the indicator starts flashing and the lighting mode changes topower-save flashing mode (where the LEDs on both ends of the unit flash alternately). Charge the product assoon as possible.* Run time is approximately 1 hour in power-save flashing mode.ClickConstant FlashingDaytimeHyperFlash Group RideSwitching the lighting modePress and holdON*OFF* When turning the light on, it lightsup in the mode that was used lasttime. (Mode memory function)WARNING!!! (Risk of death; Prevention of accidents)• To prevent accidents and to ensure safe riding, makesure the light is securely attached to the bracket and it isfunctioning properly before the ride. Do not use adamaged ladder rubber band.• Always pay attention to the remaining battery power bychecking the indicator periodically when using.• Do not disassemble or modify the light or any of theincluded items.CAUTION! (Prevention of injury, damage, or property damage)• Stop your bicycle to operate the switch.• Do not place it within children’s reach.• This device is rated IPX4 based on JIS C0920.Do not immerse the device in water. Doing so may causea malfunction. Wipe off any moisture after using thedevice in rainy weather.• Do not subject the light to strong vibrations, impacts, orexcessive force. Discontinue use if any abnormality occurs.• Do not charge the battery in any way or at any voltageother than that specified. Do not short-circuit the battery.• Do not drop the light into a fire or heat the light.• If the light unit or parts become dirty with mud, etc.,clean with a soft cloth which is moistened with mildsoap. Never apply paint thinner, benzine or alcohol;damage will result.TL-LD810TL-LD820Before using the light, read this manualthoroughly and keep it for future reference.Do not use the product in any application ormethod not described in this manual.ENGHOW TO CHARGESWITCH OPERATION1HOW TO MOUNT TO A BICYCLE32ManualDesign Pat. PendingCopyright© 2020 CATEYE Co., Ltd.TLLD810/820-201223 1LITHIUM-ION BATTERIESCautions for charging and usage:• We recommend using 500+mAh (USB2.0) USB batterycharger.• Before charging, be sure that no dust or other foreignobjects attach to the USB plug.• Do not subject the light to vibrations while charging.• When your PC is in sleep state, the unit cannot becharged.• Once charging is complete, be sure to disconnect theUSB plug.• Charging time is approximate values, and will varydepending on the environmental and usage conditions.• Charging, discharging, and storing in hightemperatures will cause the rechargeable battery todeteriorate faster. Do not place the light inside a vehicleor near a heater. Make sure to charge only when theambient temperature is between 5 and 40°C.• If the illumination time is significantly reduced evenafter proper charging, the rechargeable battery may benearing the end of its service life.Cautions on storage:• If the device will not be used for a long period of time,store it in a location that is not too hot or too humid.• Charge the battery for about 30 minutes every 6 months.Cautions for dispose:When disposing of the light unit, remove the internalrechargeable battery and dispose of it according to localregulations.Ladder rubber bandAttach the light securelyin the mounting position.Attach the ladderrubber band (B) to thebracket (A).Bracket1Mount the light unit vertically orhorizontally.or2HorizontalVerticalLight unitBABracket rubberpadFold backInsertAttach the bracket rubber pad (C)aligning it with the protrusion onthe back of the bracket (A).Fold back any excess bandand hook it on the tab.Insert the tip of the bandinto the gap.Tab34 56* The light can be mounted on aero seat posts with an outercircumference of approx. 130 mm.CAA CSeat post/stayØ21.5 – 32 mmViz300 Approx. 3 hours (0.5A)Viz450 Approx. 3.5 hours (0.5A) |
Related manuals for Cateye TL-LD810
manualsdatabase
Your AI-powered manual search engine