Cavity Sliders SofStop Installation Instructions Manual
Also see for SofStop: Installation instructions
1 Activator positioningBefore mounting the track in the opening you willneed to insert the front and rear activators into thetrack. Use the formula (right) to measure from thenotched end of the track to the center of the activator.Only tighten one screw on the activator as thisis an approximate position. Final position will bedetermined later.If your door protrudes out of the pocket in the openposition you will need to take this distance awayfrom the rear activator formula.(e.g. DW + 20¾” - 4”).These instructions cover the preparation of doors to befitted into a pocket that has the CS SofStop Track fitted.Read through the notes carefully before beginning asdifferent mounting plate positions and set-ups may berequired for different configurations.Go to page 2 (overleaf)IMPORTANTThe CS SofStop carriages require a clean track runningsurface free of any contamination or damage.After installation but before lining, clean the full lengthof the inside running surface of the track with a softrag, then TAPE UP THE TRACK to ensure no dust ordebris enter the track during building works.Make sure no dirt, grit or aluminum swarf gets intothe track. This could impair the smooth running of thecarriages.1PAGEInstallationInstructionsTwin Action Soft Open & CloseEnsure rear activator is positioned correctlyin the track BEFORE lining the wall.READ INSTRUCTIONS BEFORE INSTALL.ActivatorSlide activatorinto trackGrubscrewsNotched endof trackthe all four Activator grub screws until the activator slides freely in the track.or in the centre of the door opening and tightento fix it in position.Marked lineOpen the door and loosen the grub screw to allow the Activator to slide freely in the track.Open the door. Without moving the activator tighten one of the four grub screws.Place the 'Activator Positioning Template' at the end closest to the cavity pocket and mark a line.TORRear activatorRearactivatorRearactivatorRearactivatorFrontactivatorFrontactivatorFrontactivatorFrontactivatorTracknotchTracknotchTracknotchTracknotchDoorDoorDoorDoorTrackstopTrackstopTrack stopTrack stopACTIVATOR POSITIONINGA - Rear track stopDW + 20¾”DW + 20¾”DW + 22 7/8”DW + 22 7/8”11½”11½”13½”13½”C - Front track stopD - Front & rear track stopsB - No track stopsNote: if the activator position falls over a track mountinghole, re-drill the mounting hole in a new position. Makesure you blow out the swarf so it does not impact theperformance of the system. |
Related manuals for Cavity Sliders SofStop
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine