DAHON SPEED DIAL ULTIMATE Installation Instructions Manual
  |
Installation Tools Needed:2mm, 4mm and 5mm hexwrenches, torque wrench andcable cutters.Installation InstructionsIIMMPPOORRTTAANNTT!!Only brakes designated for direct-pulllevers such as the Single Digit Ultimate,Single Digit Ti, 7, 5 and 3 brakes can beused with Avid levers. If you have anyquestions concerning compatibility oflevers and brakes, contact your profes-sion bike dealer.Follow these instructions carefully. Ifyou do not understand the instructions,have the installation done by a profes-sional bike mechanic.11 2FFRROONNTT BBRRAAKKEE IINNSSTTAALLLLAATTIIOONNIIMMPPOORRTTAANNTTBrakes are a safety-critical item on a bicycle.Improper set-up or use of brakes can resultin loss of control or an accident, which couldlead to a severe injury.It’s your responsibility to learn and under-stand proper braking techniques. Consultthe owner’s manual for your bicycle and aprofessional bike dealer. Practice your rid-ing and braking techniques in a controlledenvironment prior to aggressive riding.The effectiveness of braking is dependent onmany conditions over which Avid has nocontrol including the speed of the bicycle,type and condition of the riding surface,braking lever force, proper installation andmaintenance of brakes, cables, levers, brakepads, the condition of the bike, weight of therider, proper braking techniques, weather,terrain, and a variety of other factors.ALWAYS RIDE UNDER CONTROL.Remember, it takes longer to stop in wetconditions. To reduce the possibility of anaccident and minimize trail erosion, youshould avoid locking-up your wheels.SDULT-0901INSTALL THE LEVERHold the lever firmly against the handle-bar in the approximate location youwant, and snap the Cam Split Clamp tmover the bar and lever.43SET THE KNOBBefore setting the brake cable length,turn the Speed Dial adjusting thumb-screw so it is in the middle of therange. After installation, adjust the knobfor the exact brake feel that you want.SET THE REACHIf you have smaller hands, you canadjust the reach of the lever by adjust-ing the reach hex bolt.INSTALL THE BOLTInsert the clamp bolt and washer fromthe front side. Support the back sideof the clamp with your finger whiletightening the bolt.Tighten Clamp Bolt to:33 - 44 NNmm ((2288 - 3366 iinn llbb))1 2 3123SET ADJUSTING BARRELBefore installing the cable, adjust thebarrel adjuster about half way out.Make sure the barrel slot lines up withthe slot in the body.You may now install the brake cable.5SlotIIMMPPOORRTTAANNTT!! - SSqquueeeezzee tthhee lleevveerr.... .TTHHEENN ttuurrnn tthhee ssccrreeww..5mm ~ 6mmSPEED DIAL®ULTIMATEBlack OpsTM Research |
Related manuals for DAHON SPEED DIAL ULTIMATE
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine