VERTICAL5-PART SYSTEM INSTALLATION INSTRUCTIONSTOOLS REQUIRED: Use either a #2 Phillips head driver or a 1/4-inch hexhead driver, as both types of screws areincluded with this sysem. To install the system, you will need:• racheting driver • screw starter • scissors• cordless drill • small hammer • file• small blade screwdriver • chalk or other marker • measuring tape• wirecuttersThe following is a list of components:. Purpose1 91 cm Dehumidifier (with attached extensions) Removes excess moisture from the piano1 Humidistat Controls the Humidifier and Dehumidifier1 Humidifier Brings moisture into the piano1 Water Sensor Probes Measure water depth in Humidifier1 Humidifier Heater Bar Warms pads to aid evaporation1 Two-light Panel Shows System is energized and when to add water1 Watering tube Enables the delivery of water to the Humidifier1 Humidifier pads Used to vaporize moisture from the Humidifier1 3 m Extension Power Cord Connects Humidistat to electrical wall outlet1 Moisture Distribution Baffle Dispenses moisture throughout the piano1 Watering Can For adding water to the Humidifier1 Bottle of Humidifier Treatment Additive that prolongs the life of the pads1 Hardware kit Described below1 System Care and Maintenance sheet / 5-Year Warranty CertificateThe hardware kit includes the following:2 Y Hangers Used to suspend the Humidifier tank when necessary13 13 mm #8 screws Mounts clamps2 19 mm #8 screws Used to attach the light panel3 5 mm clamps Attaches wire between light panel and Humidistat2 13 mm standard clamps Attaches watering tube between keybed and Humidifier2 Half clamps and serrated washers Attaches the end of the watering tube to the rim6 6 mm clamps Anchors Humidistat power cord wire2 Screw hooks Used to suspend the Humidifier when necessary. Used with Y Hangers2 Wire ties and cable ties Used to bundle excess cords4 Pin pegs Used to mount Dehumidifier and the Moisture Distribution Baffle2 Plastic hanger C clips Used to mount the Humidistat on the Dehumidifier1 “STOP, DO Not Unplug Label Can be attached to power cord near wall outlet1 Warranty Registration cardWhile we make every effort to ensure all components are included, it is a good idea to check that none are missing prior toarriving at the installation location. In the unlikely event that a part is missing, please call your supplier with information fromthe end of the box and the assembler’s name. The replacement part will be shipped to you without delay.Smart Bracket package includes:Smart Bracket Sensors Attaches to Humidifier heater bar and senses when pads are drySingle-Light Cube Signals when Humidifier pads are dry