OPERATION REMOVE ALL DEBRIS FROM THE ITEMS TO BE WASHED BEFORE PLACING THEM INTO THE BASKET. CLOSE THE DOOR, SELECT THE WASHING CYCLE TIME SWITCH 2` OR 3` MINUTE - PRESS THE CYCLE START SWITCH - THE CYCLELAMP WILL COME ON. AT THE END OF THE CYCLE THE CYCLE LAMP WILL GO OUT. OPEN THE DOOR AND PULL OUT THE BASKET - ALLOW EXCESS WATER TO RUN OFF BEFORE REMOVING.PREPARATION CHECK THE DRAIN PLUG IS PUSHED FIRMLY IN PLACE AND THE FILTER BOWL IS POSITIONED INTO THE SURFACE FILTER. CHECK THE DETERGENT ( RED ) AND RINSE AID ( CLEAR ) SUPPLY TUBES, WITH FOOT VALVES - ARE SUBMERGED INSUFFICIENT PRODUCT. CHECK THE DOOR IS CLOSED AND PRESS THE POWER SWITCH - THE POWER GREEN LAMP WILL COME ON. ALLOW 30 mins FOR THE MACHINE TO FILL WITH WATER AND REACH THE CORRECT WASHING TEMPERATURE.THE MACHINE READYLAMP WILL COME ON.OPERATING AND MAINTENANCE INSTRUCTIONSPG50 D / PD50A DROUTINE MAINTENANCE AT THE END OF A SESSION TURN OFF THE POWER SWITCH. DO NOT REMOVE ANY FILTERS AT THIS STAGE. REMOVE THE DRAIN PLUG - THE WASH TANK WILL EMPTY. MACHINES FITTED WITH DRAIN PUMP WILL AUTOMATICALLY START TOPUMP THE WATER OUT. CLEAN AROUND THE WASH TANK - DOOR SURROUNDS AND HINGES WITH AN 'ADDIS'’ TYPE WASHING UP BRUSH. COLLECT THE DEBRIS INTO THE FILTER BOWL AND REMOVE FROM THE WASH TANK. REMOVE THE SURFACE FILTER AND CLEANTHOROUGHLY. CLEAN AROUND THE LOWER WASH TANK - DO NOT ALLOW DEBRIS TO GO DOWN THE OUTLET HOLE AS THIS MAY DAMAGE YOURMACHINE. DO NOT USE CHLORIDE CONTAINING BASED CLEANING SOLUTIONS OR ABRASIVES WHEN CLEANING THE WASH TANK. REGULARLY CHECK RINSE JETS AND WASH JETS ARE CLEAR OF DEBRIS OR LIME SCALE - REMOVE IF NECESSARY BY UNSCREWINGTHE RINSE ARM NUT THAT HOLDS THE RINSE ARM IN PLACE - REMOVE THE RINSE PIN THAT HOLDS THE WASH ARM IN PLACE - CLEANBOTH THOROUGHLY AND REASSEMBLE. REMEMBER TO REPLACE BOTH THE SURFACE FILTER, FILTER BOWL AND DRAIN PLUG.POWERSWITCHCYCLE STARTSWITCHMACHINEREADYLAMP(OPTIONAL)REMOVE DRAIN PLUG AND SWITCH THE MACHINEOFF TO START THE AUTOMATIC DRAIN PUMPCYCLE TIMESWITCHCYCLESELECTIONLAMPWATER SOFTENER REMEMBER TO REGENERATE THE EXTERNAL WATER SOFTENER IF FITTED REGULARLY. ENSURE THAT THE WATER VALVESARE TURNED BACK ON TO SUPPLY THE MACHINE WITH FULL MAINS PRESSURE SOFTENED WATER.OUTLET HOLEFILTER BOWLDRAIN PLUGSURFACE FILTERWASH ARMFOOT VALVES FORCHEMICALCONTAINER TUBESRINSE ARM NUTRINSE JETSWASH JETSRINSE PINRINSE ARMWASHINGCYCLE LAMPSERVICE CALLS TO RECTIFY FAULTS CAUSED BY `THE LACK OF ROUTINE MAINTENANCE` WILL BE CHARGED FORAND YOUR WARRANTY MAY BE AFFECTEDwww.directcatering.co.uk