DECKED.COM | #DECKEDUSA | @DECKEDUSA TBFDL | v.1 | Page 1@DECKEDUSA | #DECKEDUSAFOLLOW US:LADDER INSTALLATION TOOLS NEEDED:• 5/32” hex wrench• Rest the folded ladder on a table or hard surface so that you can read the instructions on the bottom of the first rung.• While holding the top rung, pull the bottom rung from the ladder assembly until both the bottom and middle rungs lock in place.• Set the ladder on the ground vertically next to the passenger side of your Tool Box.• Raise both arms and extend them up and over the edge of the Tool Box to meet with the mounting discs. NOTE: The ladder brackets must be facing down.• Using a 5/32” hex wrench, install the hardware in the order shown, DETAIL A. Repeat on opposite side. Tighten until snug - DO NOT OVERTIGHTEN.• Return the ladder to the Tool Box by collapsing the rungs and folding back into place.➡ CABADETAIL ALADDERBRACKET“CLICK”STEP 1▼ WARNING DON’T DO THIS ▼“CLICK” AGAINSTEP 2 STEP 3USING THE LADDER:WATCH LADDER INSTRUCTIONAL VIDEOS:DECKED.COM/LADDERPLACE LADDER ON SOLID GROUNDWITH BOTH RUNGS LOCKED INTOPLACE (LADDER STEPS 1-3). FAILURETO DO THIS COULD ALLOW LADDERTO SWING INTO TRUCK AND CAUSEDAMAGE TO THE VEHICLEPOSITION LADDERVERTICALLY TOSOLID GROUND