Quick Install GuideCB-5222 Analytic Bullet IP Camera1. From the navigation bar, select Settings > Camera > Misc.2. From the TV System dropdown list, select the required videoformat (PAL/NTSC). The default video format is PAL.3. Click SET to save settings. The unit resets and the new settingis configured.4. From the Live screen, adjust the Zoom so that it includes therequired Field of View.5. Focus the lens automatically or manually.NOTE: Changing the video format restores the unit to factorydefaults and deletes any analytic configuration that was setpreviously.1. Select one of the following power connections:• Connect the Ethernet cable on the system cable from thecamera to a PoE+ switch/injector(for operation at -40° to 50° C/-40° to 122°F)• Connect the camera’s power cable to a 12VDC (1.6 amps),24 VDC (0.8 amps), or 24VAC (0.85 amps) power supply(for operation at -40° to 50° C/-40° to 122°F)• Connect the Ethernet cable on the system cable from thecamera to a Power over Ethernet (PoE) switch/injector(for operation at -10° to 50°C/14° to 122°F)2. Connect the analog video, audio in, audio out, alarm cablesas required for your system.You can also select the video format in DNA from the contextmenu by clicking Change Video Format, or from the DeviceProperties screen of the Properties tab.1. Download DNA from http://www.dvtel.com/services-support/firmware-software/.2. Click the DNA icon and run the DNA utility (DNA.exe). DNA discovers alldevices on the same VLAN and displays the device’s current IP address. DNAversion 2.1.x.x and above supports CB-5222.3. Do one of the following:a. If you know the unit’s IP address, enter the IP address in your browser(Internet Explorer 8 and above). The units’ Login window opens.b. If you do not know the unit’s IP address, double-click the units in DNA’sDiscovery List. The unit’s Login window opens in your browser.NOTE: Refer to the DNA 2.1 User’s Manual for details how to use DNA.PoE/PoE+AC/DC4. Enter the user name (“admin”) and password (“admin”). The device’sweb interface opens.