NETWORKCONNECTIONPOWERQuick Start GuideWHAT’S IN THE BOXQSG Manual 1 Set Mount Bolt & Nut– 2pcs 1 SetManual CD 1 Set Mount Plate 1 SetTemplate Sheetfor installing byBolt & Nut1 Set Screw & PlasticAnchor – 3pcs 1 SetTemplate Sheetfor installing by Plate 1 Set Torx Wrench 1 SetUsername: admin Password: adminAttention: This document is intended to serve as a quick reference page for initial set-up.It is recommended that the user read the entire instruction manual for complete and proper camera usage.Tel: 866-446-3595 / 813-888-9555Technical Support Hours: 9:00AM – 8:00PM EST, Monday thru Fridaydigital-watchdog.comQuick Start GuideStep 1 – PREPARING TO MOUNT THE CAMERA Soft Surface InstallationStep 3 – INSTALLING THE CAMERAStep 2 – CABLING THE CAMERA TO EXTERNAL DEVICES1. The mounting surface must bear five times the weight of your camera.2. Do not let the cables get caught in improper places or the electric line cover to be damaged.This may cause a breakdown or fire.3. For the installation process, remove the dome cover and rubber gasket from the camera moduleby loosening the screw on the side of the dome. Use the wrench provided with the camera.4. Using the mounting template sheet or the camera itself, mark and drill the necessary holes inthe wall or ceiling.For soft installation surfaces, use the includedmetal mount plate. Fix the mount plate on themounting surface using the included screws.Then, press the bottom case onto the mountplate. The three bezels on the case will alignand snap lock onto the plate.6. Once all cables are connected, secure the camera to the mounting surface using the included screws.7. Re-attach the camera’s gasket ring and dome to the camera module by aligning the screw holes.8. The camera includes a sensor at the camera’s module. For the sensor to function properly, the camera’sdome includes a special hole for the sensor.9. When assembling the camera together, please make sure the sensor hole in the camera’s dome ispositioned right on top of the sensor on the camera’s module.5. Pass the wires through the mount bracket and make all necessary connections.a. NETWORK CONNECTIONS – If you are using a PoE Switch, connect the camera using an Ethernetcable for both data and power.b. NETWORK CONNECTIONS – If you are using a non-PoE switch, connect the camera to the switchusing an Ethernet cable for data transmission and use a power adapter to power the camera.Power Requirements Power Consumption12V DCPoE [IEEE802.3at, Class 3]12VDC: 6W (LED On)PoE: 7W11223 5756644TemplateSheetTemplateSheetDWC-PF5M1TIR