Da-Lite ADVANTAGE DELUXE ELECTROL Specification

Also see for ADVANTAGE DELUXE ELECTROL: Instruction book Specification data Instruction book Instruction book Instruction book

Da-Lite ADVANTAGE DELUXE ELECTROL Specification Manual pdf 1 page image

SPECIFICATION DATAADVANTAGE® DELUXEELECTROL ®Automatic Electric Projection Screen ModelSUGGESTED SPECIFICATIONS: projection screen(s), (H) x (W). The Advantage ® DeluxeScreen shall have two motors, one to operate door and one to operate screen. Door motor electrically operated 120 volt (60 Hz) not morethan 1.2 amp, mounted inside the roller, to be three wire with ground, quick reversal type, oiled for life, with automatic thermal overloadcutout, integral gears, capacitor and an electric brake to prevent coasting. To have pre-set but adjustable limit switches to automaticallystop fabric door in the ”down“ position. The door will lift to the closed position where a micro switch shall cut off the electrical current tothe door motor. Screen motor is electrically operated 120 volt (60 Hz) not more than 2.4 amp, mounted inside the roller, to be three wirewith ground quick reversal type, oiled for life, with automatic thermal overload cutout, integral gears, capacitor and an electric brake toprevent coasting. To have pre-set but adjustable limit switches to automatically stop picture surface in the ”up“ and ”down“ positions.The roller to be of rigid metal. Screen fabric to be flame retardant and mildew resistant fiberglass with black masking borders standard.Bottom of fabric shall be formed into a pocket holding a metal rod with plastic caps. Case shall be a white powder coated aluminumextrusion. Bottom of case to be self-trimming with a built-in flange around the bottom of the case. A section of the bottom of the caseshall be an aluminum door equipped with concealed hinges so that it opens and closes automatically with the lowering and raising of thepicture surface. The balance of the bottom of the case shall be a second hinged aluminum door with manual opening to provide access.Junction box shall be internally integrated into the housing making it possible to install the housing and wire to the building’s electricalsystem during construction. The junction box shall contain a quick connect connector that is mounted in the housing for easy plug-inconnection to the motorized fabric and roller assembly. The motorized fabric and roller assembly to be installed in the case at the factoryor at a later time at the job site. To be complete with integrated low voltage control unit and three position control switch with coverplate. Suitable for use in environmental air space in accordance with section 300-22 (c) of the National Electric Code, and sections 2-128,12-010 (3) and 12-100 of the Canadian Electrical Code, part 1, CSA C22.1. Screen to be listed by Underwriters’ Laboratories.9 1 /4"(SUGGESTED) 3/ 8 "THREADED ROD(NOT INCLUDED)ATTACHED TOMOUNTINGBRACKETFINISHEDCEILINGSELF-TRIMMINGFLANGE7 1 /4 "8 3 /4"CASE LENGTHVARIABLE POSITIONMOUNTING BRACKETS71 /4 "71 /4 "6 1 /8 "MOTOR END6 1/ 8"ELECTRICALJUNCTION BOXDOORROLLERSCREENROLLERSCREENDOORACCESSDOORAUDIENCESIDESELF-TRIMMINGFLANGE3 3/ 8 " 53/ 8"SUGGESTED CEILINGINSTALLATIONOptional Accessories:o Extra Drop available to lower picture areamore than normal. Specify total drop attop _____ (black or white) or at bottom_____ (black or white). 13' maximumtotal surface height including picturearea.o No borders (Black masking bordersstandard).o Wireless Remote Control for LVC.o Radio Frequency Remoteo Radio Frequency Range Extendero Infrared Remoteo Key Locking Cover Plate for 120V Switchor LVC.o 220/240 Volt (50 Hz) Motor.o Video Projector Interface Control - built-ino SCB-100 RS-232 Serial Control Board -built-ino NET-100 Ethernet-Serial Adaptero SCB-200 RS-232 Serial Control Board -built-ino NET-200 Ethernet-Serial Adaptero WC-200 Wall Controllero IR-200 Infrared RemoteProject:Architect:Phone:Contractor:Phone:Supervisor:Phone:Supplier:Date:Revised:Matte White: Horizontal seam required when both dimensions exceed 10'.High Contrast Matte White: Available in sizes where both dimensions do not exceed 10'.Video Spectra 1.5: Available in sizes up to 8' in height.Silver Lite 2.5: Available in sizes up to 8' in height and width.High Power®: Horizontal seam required when both dimensions exceed 8'.WHEN ORDERING, MARK APPROPRIATE SELECTIONS:Select size from charts on the other side.Select viewing surface:o Matte White o High Contrast Matte Whiteo Video Spectra 1.5 o High Power ®o Silver Lite 2.5GreenGuard® and GreenGuard® Children and Schools Certified.Da-LiteA Milestone AV Technologies Brand3100 North Detroit StreetPost Office Box 137Warsaw, Indiana 46581-0137P: 574.267.8101 or 800.622.3737F: 574.267.7804 or 877.325.4832E: info@da-lite.comwww.da-lite.com

/ 2

Related manuals for Da-Lite ADVANTAGE DELUXE ELECTROL