Pivoting Da-Lift26P and 33PForm E-453Rev. 08 / 10Caution: This product is designed for ceilinginstallation only. Qualified personnel using the appropriatefasteners should mount the Pivoting Da-Lift. The surfaceto which this unit is mounted must be capable ofsupporting a static load of four times the combined weightof the projector and mount. Do not attach to plaster ordrywall alone.IMPORTANT SAFETY INSTRUCTIONSWhen using your video equipment, basic safetyprecautions should always be followed, including thefollowing:1. Read and understand all instructions beforeusing.2. Position the cord so that it will not be trippedover, pulled, or contact hot surfaces.3. If an extension cord is necessary, a cord with acurrent rating at least equal to that of theappliance should be used. Cords rated for lessamperage than the appliance may overheat.4. To reduce the risk of electric shock, do notdisassemble this appliance. Contact anauthorized service dealer when repair work isrequired. Incorrect reassembly can causeelectric shock when the appliance is usedsubsequently.5. The use of an accessory attachment notrecommended by the manufacturer may causea risk of fire, electric shock, or injury topersons.SAVE THESE INSTRUCTIONSRequired Tools:- 7/16” wrench- 1/2” wrench- 9/16" wrench- Phillips screwdriverIMPORTANT INSTALLATION NOTESIf installing this unit in “other space usedfor environmental air”, it must be installedwith the plenum cover available fromDa-Lite Screen.This unit must be installed in accordancewith the requirements of the Local BuildingCodes, the Canadian Electrical Code(CEC), CAN/CSA C22.1 and the NationalElectrical Code (NEC), NFPA 70.Suitable for Use in Other EnvironmentalAir Space in Accordance with Section300.22(c) of the National Electrical Code,and Sections 2-128, 12-010(3) and 12-100of the Canadian Electrical Code, Part 1,CSA C22.1.