PLANNINGGUIDEwww.Dacor.com Phone: (800) 793-0093Specifications subject to change without notice.Install all appliances according to accompanying installation instructions. 4.14A30” and 36” Wide, Distinctive SeriesSlide-in Gas CooktopsDRT304S, DRT366SELECTRIC CIRCUIT REQUIREMENTSCircuit Required Total Connected Load120 Vac 60Hz, 15 Amp. (3 wire) 1.0 Amp @ 120 Vac, 60 HzGAS SUPPLY PRESSURE REQUIREMENTS*Gas Type Manifold Pressure Minimum Gas SupplyPressureNatural Gas 5” Water Column 6” Water ColumnPropane (LP) 10” Water Column 11” Water Column* Maximum gas supply pressure for all models is 1/2 p.s.i.Installation of a non-combustible material* (up to the hood) or a backsplashis always recommended, and mandatory if the distance to the backwall from the cooktop is less than 2 1/2” (Figure 2). When installinga backguard, use only Dacor model numbers AEB3009, AEB3012(DRT304S), AEB3609 or AEB3612 (DRT366S).SIDE VIEW WIThoUT BACkGUARDSIDE VIEW WIThoUT BACkGUARDSIDE VIEWProduct DimensionsElectrical and Gas Supply RequirementsCabinet and Countertop LayoutCOOKTOP WIDTH (A)DRT304S 29 7/8” (759 mm)DRT366S 35 7/8” (911 mm)Product tolerances:±1/16” (±1.6 mm)unless otherwise notedWARNINGObserve all governing codes and ordinances during planning•and installation. Contact your local building department forfurther information.This appliance must be installed in accordance with the•accompanying installation instructions.Document # PG04 - 003 Revised 02/16/10 Page 1/34” (102 mm) 5/8” Min.(16 mm)7 3/4”(197 mm)Trim:1/2”(13 mm)thick25 7/8” (657 mm)1 5/8” (41 mm) cooking surfaceheight (grate level) abovecountertop3/4” gas inlet, connects to regulator frombottom or rear of unit, end is recessed2” (51 mm) from chassis bottom28 1/8” (714 mm)Power cord32” longCombustiblerear wallBackguard mandatory ifgap from back of cooktopto combustible wall is lessthan 2 1/2”Combustiblerear wall2 1/2” (64 mm) Min. tocombustible rear wall