Dakota Digital HLY-6000 Manual

Dakota Digital HLY-6000 Manual Manual pdf 1 page image

MODEL HLY-6000BAR MOUNTSPEEDOMETER/TACHOMETERINFORMATION SYSTEMPlease read this before beginning installation or wiring.POWERConnect the red wire from the main harness to accessory power from the ignition switch. In addition topowering the display system, this is also where the low voltage detection circuit monitors the electrical systemvoltage.A good quality, solid state ignition switch should be used. The contacts on a mechanical “bar” switch canbounce due to the vibration and cause the system to momentarily loose power and reset itself.Never connect this to a battery charger alone. It needs to have a 12 volt battery connected to it. Batterychargers have an unregulated voltage output that will cause the system to not operate properly.GROUNDThe black wire is the main ground for display system. This should be connected directly to the negativecable on the battery. Connecting to a tank or frame ground can cause a weak or intermittent ground connection. Apoor ground connection can cause improper or erratic operation.NEUTRAL, TURN SIGNAL & HIGH BEAM INDICATORSThe right turn, leftturn, and high beam indicatorsare activated by 12 volts attheir respective hook-up wires.The right turn signalwire is green, the left turnsignal wire is orange, and thehigh beam wire is purple.These can be connected tothe same wires that theindicator lights are connectedto. The display system wirecolors may not match the wirecolors in your electrical wireharness.The neutral indicatoris activated when the blue wire is grounded. Connect this wire to the neutral switch or to the negative side of theneutral indicator light. When the indicator is activated, an N will be lit up to the right of the speedometer.TRIP RESET & FUNCTION SWITCHThe push button switch is found on the front face of the display. To reset the trip mileage, press and holdthe switch in. Pressing the switch while turning power on will enter the setup menus.