Dakota Digital MCL-30K-SPD Installation Manual

Dakota Digital MCL-30K-SPD Installation Manual Manual pdf 1 page image

1 MAN#650334:AMCL-30K-SPDThank you for purchasing the Dakota Digital MCL-30K-SPD gauge for your Harley Davidson Touring bike. This isdesigned to be a replacement for all touring models from 1996 – 2003. This is part of a six gauge package for touringmodels so you can add additional gauges as you choose.INSTALLATIONFirst read and familiarize yourself with all of the components and this manual. The first step is to remove theseat and disconnect the negative side of the battery, as with any electronic install. Once the battery is disconnected youare ready to start.Remove the outer fairing for FLHT models; this will vary from model to model, please follow the service manualto expose the wiring and gauges. Road Glide (FLTR) models will not need the outer fairing removed.Ultra (FLHT) with outer removedRemove Factory GaugesNow you are ready to start unplugging and removing the original speedometer.ULTRA FLHT (batwing fairings)Remove the clamps that hold the Speed and Tach in place with a screw driver or wrench depending onapplication, and remove the gauges.Remove speedo cable/unplug gauges Remove nuts/screws and clamp to remove factory gaugesIMPORTANT NOTE! This gauge has an odometer preset option that is only available for the first100 miles (160km) of operation. See “preset odometer” for instructions.