Dancing Wings Hobby VX14 Instruction Manual

Dancing Wings Hobby VX14 Instruction Manual Manual pdf 1 page image

VX14 BLERIOT XI INSTRUCTION MANUAL材质 Material:1. 椴木 Basswood2. 巴尔莎木 Balsawood3. 桐木 Paulownia4. 碳杆和其他carbon rod and others工具 Tools Needed各部件用美工刀从板材上取下，按下图图示及步骤拼装，木质部件建议用快干胶(502)定型，用白乳胶加固。Pls take down the parts from the board by knife,and assemblethem as per the procedures as below,we suggest you to shapewith 502 glue,and firm withwhite latex.1.机身组装 Fusalage InstallationLWB1.1 1.21.31.41.51.61.72.1 2.22.31.8 1.92.机轮及滑橇组装 Landing Gear Installation2.４ 2.53.机翼组装 Wing Installation4.尾翼组装 Tail Assembly2.63.13.23.33.4 3.53.64.1 4.2C1C1D1U1F4F6C2C2F7F8F9F5F3F3 F3-1F3-1F3-1BBF2F1F11F13G1G1G2-1G2F14F15F12粘C2上端板时调整机身后端角度。Adjust the rear angle of the fuselagewhen you stick the C2 upper plate.在平整工作台面拼装L1-L3，保持机翼平直。Assemble L1-L3 on a flat work desk andkeep the wing straight.左右机翼拼装方法相同，注意:请对称拼装，不要拼成顺边。完成后机翼相对插到机身。The left and right wings are assembled in the same way.Note:please assemble symmetricallyinstead of along the edge.After completion,insert the wings into the fuselage从LX取下木条，安装到机翼翼梁卡口内，按实际长度截取。Remove the wood strip from LX, install them into the wingbeam bayonet, and cut them according to the actual length.截取1根83mm 碳杆，如图安装。Cut one 83mm carbon rod andassemble as picture shown.注意：此处机轮为可转动设计，请勿粘固机轮。Note: the wheel is rotatable ,please do not stick the wheel.对齐AlignG10G3G4G3G3G4G3W组装2个Assemble 2 pcs组装4个Assemble 4 pcsG5 G8 G9G9G6F7L1L3L2W1F10R1R2W1W1W1W1W1W1W1W3W4W5W2F812mm不粘 Non-stick粘固 Stick 粘固 Stick正面front背面backF4粘到机身末端，对齐两侧板。Stick the F4 to the fuselage end, and align the2pcs side plate.对齐Align截取2根70mm 碳杆，如图安装。Cut two 70mm carbon rodsand assemble as pictureshown.按实际长度截取3根短木杆，如图粘贴安装并打磨棱角。Cut three short wooden rodsby actual length,paste aspicture and polish the edges.截取20mm 碳杆，如图安装。Cut one 20mmcarbon rod andinstall as pictureshown.

/ 2

Related manuals for Dancing Wings Hobby VX14