Danfoss FC 300 Programming Manual

Also see for FC 300: Operating instructions Instruction manual Design guide Design guide Design guide

Danfoss FC 300 Programming Manual Manual pdf 1 page image

Contents1 Introduction 31.1.1 Approvals 31.1.2 Symbols 31.1.3 Abbreviations 31.1.4 Definitions 41.1.5 Electrical Wiring - Control Cables 82 How to Programme 122.1 The Graphical and Numerical Local Control Panels 122.1.1 How to Programme on the Graphical LCP 122.1.2 The LCD-Display 132.1.4 Display Mode 152.1.5 Display Mode - Selection of Read-Outs 152.1.6 Parameter Set-Up 172.1.7 Quick Menu Key Functions 172.1.9 Main Menu Mode 192.1.10 Parameter Selection 192.1.14 Infinitely Variable Change of Numeric Data Value 202.1.16 Read-out and Programming of Indexed Parameters 202.1.17 How to Programme on the Numerical Local Control Panel 202.1.18 Local Control Keys 222.1.19 Initialisation to Default Settings 223 Parameter Descriptions 233.2 Parameters: 0-** Operation and Display 233.3 Parameters: 1-** Load and Motor 333.4 Parameters: 2-** Brakes 473.5 Parameters: 3-** Reference/Ramps 523.6 Parameters: 4-** Limits/Warnings 623.7 Parameters: 5-** Digital In/Out 673.8 Parameters: 6-** Analog In/Out 853.9 Parameters: 7-** Controllers 943.10 Parameters: 8-** Communications and Options 993.11 Parameters: 9-** Profibus 1083.12 Parameters: 10-** DeviceNet CAN Fieldbus 1143.13 Parameters: 12-** Ethernet 1183.14 Parameters: 13-** Smart Logic Control 1223.15 Parameters: 14-** Special Functions 1343.16 Parameters: 15-** Drive Information 1423.17 Parameters: 16-** Data Read-outs 146Contents FC 300 Programming GuideMG.33.M9.02 - VLT® is a registered Danfoss trademark 1