FP735 SiEasy User InstructionsProgramming the Heating - 24 hour mode1. Press the CH button to display the zone you wish to programme (C1, C2or C3)2. Press PROG until E1 flashes (Event 1)3. Use the + or - buttons to set the time you want your heating to first comeon in the morning (Event 1)Continue programming the central heating ON and OFF times bypressing:a) NEXT button to move to the next setting;b) + or - buttons to amend the time4. Press and release the PROG button to return the unit to RUN mode(the time appears and the colon in the display begins to flash)Programming the Heating - 5+2 day mode1. Press CH button to display the zone you wish to programme (C1, C2 orC3)2. Press PROG until E1 flashes (Event 1), then press the DAY button untilthe days of the week are shown in the display.3. Use the + or - buttons to set the time you want your heating to first comeon in the morning (Event 1)Continue programming the central heating ON and OFF times by pressing:a) NEXT button to move to the next setting,b) + or - buttons to amend the time.4. When all events are correct, press DAY to programme events for theweekend. or press the COPY button to repeat the weekday programme.5. Press and release the PROG button to return the unit to RUN mode (timeappears and the colon in the display begins to flash.Programming the Heating - 7 day mode1. Press CH button to display the zone you wish to programme (C1, C2 orC3)2. Press PROG until E1 flashes (Event 1)3. Use the + or - buttons to set the time you want your heating to first comeon in the morning (Event 1)Continue programming the central heating ON and OFF times by pressing:a) NEXT button to move to the next setting, b) + or - buttons to amendthe time.4. When all events are correct, press DAY to programme events for the nextday. (If a day’s event times are to be repeated in another day of the week,then the COPY function can be used - see below).5. Repeat steps 3 and 4 above or press the COPY button to copy the previousdays events).6. Press and release the PROG button to return the unit to RUN mode (timeappears and the colon in the display begins to flash.H12412345or3or123465orThe FP735 Si is a three channel programmer, depending on your home, the various channels, C1, C2 or C3 will be assigned to one ortwo heating zones (upstairs and downstairs) and the remaining channel for hot water. Your installer should be able to confirm whichchannel has been assigned to hot water and which remaining channels are assigned to which heating zone.The heating will not work if the room thermostat has switched the heating off. And, if you have a hot-water cylinder, the water heatingwill not work if the cylinder thermostat detects that the hot water has reached the correct temperature.