Danfoss MCD 200 Installation Instructions Manual

Also see for VLT MCD 200: Design guide Installation instructions Installation instructions Installation guide Installation guide

Danfoss MCD 200 Installation Instructions Manual Manual pdf 1 page image

MCD USB Module Instructions IntroductionMI.17.C1.02 – VLT® is a registered Danfoss trademark 1INSTALLATION INSTRUCTIONS: MCD USB MODULE1. IntroductionThe USB Module can be used in conjunction with WinMaster to manage Danfoss soft starters.These instructions detail the installation, set-up and configuration of the USB Module. For details onusing WinMaster, refer to the WinMaster help file.2. InstallationCAUTIONRemove mains and control voltage from the soft starter before attaching or removing accessories.Failure to do so may damage the equipment.MCD 200Plug the module onto the side of the soft starter.MCD 500:To plug the module onto the side of the soft starter, linethe interface up with the comms port slot.Press the top retaining clip of the module into the softstarter chassis first, then press in the bottom retainingclip.177HA585.10Remove the module using the following procedure:1. Remove control power and mains supply from the softstarter.2. Take the module off-line.3. Disconnect the USB cable from the module.4. Push a small flat-bladed screwdriver into the slots at the topand bottom of the module and depress the retaining clips.5. Pull the module away from the soft starter.