Danfoss TS715 Operating Instructions Manual

Also see for TS715 Si: Installation & user's instructions Installation & user's instructions Installation & user's instructions User instruction

Danfoss TS715 Operating Instructions Manual Manual pdf 1 page image

6Systems with dial thermostats continuedOperating instructions for the underfloor heating timeclocksTS715 – Single-channel timeclockNu-Heat supplies Danfoss TS715 single-channel programmable floor heatingtimeclocks to control the underfloor heating system.Room zone temperatures are individually controlled by simple dial-type thermostats.Please remember that underfloor heating takes longer to warm up and cool downthan conventional radiators and the timeclock settings should reflect this.Ensure that each timeclock is set to your requirements as follows:-Programming – day and time1. Open the cover. Press prog to enterprogramming mode.2. Press day to select day of the week.Repeat until correct day is displayed.3. Use + or - to adjust the time untilcorrect.SELECTPROGNEXT ON/OFF+–DAYCOPYR/S12:00 PMMOONOFFAUTOALL DAY+1HRMANSELECTPROGNEXT ON/OFF+–DAYCOPYR/S12:00 PMTUSET TIME+1HRMANSELECTPROGNEXT ON/OFF+–DAYCOPYR/S12:02 PMMOSET TIME+1HRMANSELECTPROGNEXT ON/OFF+–DAYCOPYR/S12:00 PMMOSET TIME+1HRMANSELECTPROGNEXT ON/OFF+–DAYCOPYR/S4:30 AMMOSET TIME1ON+1HRMANSELECTPROGNEXT ON/OFF+–DAYCOPYR/S8:00 AMMOSET TIME2OFF+1HRMANSELECTPROGNEXT ON/OFF+–DAYCOPYR/S11:15MOSET TIME6OFFPM+1HRMANSELECTPROGNEXT ON/OFF+–DAYCOPYR/S12:30 PMTUSET TIME4OFF+1HRMANSELECTPROGNEXT ON/OFF+–DAYCOPYR/S11:15 PMFRSET TIME6OFF+1HRMANProgramming – on/off times4. Press prog to enter on/offprogramming mode.5. Use + or - to adjust the 1st on time,(setting number 1).6. Press next to step to 1st off time,(setting number 2).7. Use + or - to adjust the 1st off time,(setting number 2).8. Press next and repeat steps 5 – 7until all on/off times areprogrammed to suit.9. If unit is pre-set for 24 hour operationgo to step 13, If a different cycle isrequired, alter the internal pins andcontinue with step 10 (see opposite).10. Press day to advance to the next dayif different programming from theprevious day is required.If the programme is the same, goto step 11.11. Press the copy button to copy theprevious day’s programming to thecurrent day.12. Repeat steps 10 – 11 until all daysare programmed.13. Press prog to return to run mode.

/ 2

Related manuals for Danfoss TS715 Si