VLT® 5000 INTERBUSMG.10.O1.02 VLT is a registered Danfoss trademark 1ContentsChapter 1 Introduction .............................................................. 2Chapter 2 Interbus introduction ................................................ 4Chapter 3 Technical Data ......................................................... 5Chapter 4 Ordering number ...................................................... 6Chapter 5 Cable routing and Connectors ................................. 7Chapter 6 Process Data ......................................................... 13Chapter 7 Drivecom 21 Profile & Interbus objects ................... 15Chapter 8 FC Profile ................................................................ 23Chapter 9 VLT Parameters ...................................................... 26Chapter 10 Timming ................................................................. 30Chapter 11 Warning and Allarm messages ................................ 31Chapter 12 Abreviations & definitions ........................................ 32Chapter 13 VLT5000 Parameter list .......................................... 33Copyrights, Limitation of Liability and Revision Rights.This publication contains information proprietary to Danfoss A/S. By accepting and using this manual the useragrees that the information contained herein will be used solely for operating equipment of Danfoss A/S orequipment from other vendors provided that such equipment is intended for communication with Danfossequipment over a INTERBUS serial communication link. This publication is protected under the Copyright lawsof Denmark and most other countries.Danfoss A/S does not warrant that a software program produced according to the guidelines provided in thismanual will function properly in every physical, hardware or software environment.Although Danfoss A/S has tested and reviewed the documentation within this manual, Danfoss A/S makes nowarranty or representation, either express or implied, with respect to this documentation, including its quality,performance, or fitness for a particular purpose.In no event shall Danfoss A/S be liable for direct, indirect, special, incidental, or consequential damages arisingout of the use, or the inability to use information contained in this manual, even if advised of the possibility ofsuch damages. In particular, Danfoss A/S is not responsible for any costs including but not limited to thoseincurred as a result of lost profits or revenue, loss or damage of equipment, loss of computer programs, loss ofdata, the costs to substitute these, or any claims by third parties.Danfoss A/S reserves the right to revise this publication at any time and to make changes in its contentswithout prior notice or any obligation to notify previous users of such revisions or changes.