Darrol Cady DCRC Aerobatic 3D Foamy Instruction Manual
        | |
Contents | 
DCRC Aerobatic 3D FoamyInstruction Manual ©Thank you very much for your purchase of theDCRC Aerobatic 3D Airplane!Recommended Equipment:Radio: 4 to 6 channel w/micro receiverServos: 4 micro servosMotor: Hacker A20-22L (Other motors will work, but this is the best we have found.)Speed Controller:Phoenix 25, Thunderbird 18,Hacker X-20Battery: Thunder Power 3 cell 1320mAhPropeller: APC 10 x 4.7 to 11 x 3.8 sloflyItems needed to complete construction Recommended power system andelectronicsYard stick or tape measure Motor: Hacker A20-22L brushlessRuler Speed control Hacker X20 or Phoneix 25 orFoam safe medium CA and CA accelerator Thunderbird 18Roll 1” Blenderm hinge tape Servos: 4 Sub Micro.032 music wire Battery: 3 cell 1320 Lithium Polymer1/8” diameter heatsrink tubing Receiver: 6 channel microHobby knife with #11 bladesDouble- sided tapeRecommended power system is available at www.darrolcady.comNOTE: THESE INSTRUCTIONS ARE GOOD FOR ALL OF OUR FOAM AIRPLANESTip: Before you begin assembly, remove all parts from the box, take a few minutes to readthough the instructions and familiarize yourself with the construction steps.1Set everything out on your construction table. This will make parts identification a lot easier! |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine