Installation Diagram – Front View Installation Diagram – Back ViewWARNING DataComm Electronics’ products shall be installed and used only as indicated in DataComm Electronics’ product instruction sheets. Instruction sheets are available online at www.datacommelectronics.com.CAUTION For shock protection, this device must be properly grounded. Use copper wire only with this device.IMPORTANT INSTRUCTIONS Read and understand all instructions. Follow all warnings and instructions marked on the product. Do not use this product near water, for example near a bath tub, wash bowl, kitchen sink, laundry tub, in a wet basement, or near aswimming pool. SAVE THESE INSTRUCTIONS.Instruction / Installation SheetExpandable Media Boxwith 20 Amp Duplex ReceptaclePart # 45-0052-WHDataComm Electronics, Inc.6349 Peachtree StreetNorcross, GA 30071-1725888.223.7977770.662.8205www.DataCommElectronics.comParts Included:• Expandable Media Box with Expandable Cavity• Steel Electrical Box with four (4) Mounting Screws• 20 Amp/125 Volt Tamper Resistant Duplex Receptacle• Flexible Pass-Through Accessory Plate• Six (6) Port Keystone Accesory Plate• Blank Accessory PlateTools Required:• Drill with Phillips Bit or Phillips Head Screw Driver• Pen or Pencil• Sheetrock Saw or Utility Knife• 6 Ft. Tape MeasureUse the Exandable Media Box with 20 Amp Duplex Receptacle to install low voltage cables behind your HDTVor other display device. The Media Box can be installed with the receptacle on the left or right side (seeInstallation Diagram below).Features of the Expandable Media Box with 20 Amp Duplex Receptacle include:• Compact size fits behind small and large TV’s• Expandable Cavity adds accessible storage space inside of the wall• HDTV/display device plug recesses completely into the wall when plugged into the Media Box• Flexible Pass-Through Accessory Plate conceals low voltage pass-through openingPage 1 of 2 05/01/2014Concealed WiringHiddenStorageCavity(hidden in wall)Flat Screen TVFlat Screen TVConcealed Wiring(hidden in wall)HiddenStorageCavity