D-200 MK2 User Manual Firmware V-6.3D-200 MK2ADVANCEDGENSETCONTROLLERThe D-200-MK2 is a next generation genset control unitcombining multi-functionality and wide communicationpossibilities together with a reliable and low cost design.The same controller provides AMF, ATS, Remote Start,Engine Control functionalities.The module comes ready for remote monitoring overGSM or Ethernet with plug-in communication modules.Various plug-in modules provide unlimited expansioncapabilities allowing to meet any special requirement.The unit complies and mostly exceeds world’s tightestsafety, EMC, vibration and environmental standards forthe industrial category.Software features are complete with easy firmwareupgrade process through USB port.The Windows based PC software allows monitoring andprogramming through USB, serial and GPRS.The Rainbow Scada central monitoring service allowsmonitoring and control of an unlimited number ofgensets from a single central location.AMF unitATS unitRemote start controllerManual start controllerEngine controllerWaveform display of V & IHarmonic analysis of V & ICTs at genset or load side• GSM Modem (2G-3G-4G) *• Ethernet 100Mbps *• Wi-Fi *• RS-485 isolated (2400-57600baud) *• RS-232 isolated (2400-57600baud) *• USB Device• J1939 CANBUS (optional)• Web monitoring *• Web programming *• Central Monitoring through internet *• SMS message sending *• E-mail sending *• PC software: Rainbow Plus• Central monitoring *• Modbus RTU through RS-485 *• Modbus TCP/IP **Optional with plug-in module3 phases 4 wires, star & delta3 phases 3 wires, 3 CTs3 phases 3 wires, 2 CTs2 phases 3 wires1 phase 2 wiresFUNCTIONALITIESCOMMUNICATIONSTOPOLOGIESDESCRIPTION