MemorTM X3 Multi-slot Dock EthernetThe Multi-slot Dock Ethernet paired with a Memor X3 mobilecomputer builds a reading system for the collection, decodingand transmission of barcode data.The Multi-slot Dock Ethernet can charge up to four terminalsand provides Ethernet connection for data transfer via local areanetworks.822001822 (Rev A) Jan. 2018M OBILE COMPUTER I NSERTION /R EMOVALFor correct insertion into the dock, insert the Memor X3 from thetop of the dock and push it down.To remove the mobile computer from the dock, pull it upwardswhile holding the dock firmly down.LED I NDICATORSPower LED Status IndicatorETHERNET C ONNECTIONThe Multi-slot Dock Ethernet drivers are pre-installed on theMemor X3 and initiate automatically when the terminal is placedin a properly connected Multi-slot Dock Ethernet.When the Memor X3 is inserted into the Multi-slot Dock Ether-net, the connectivity icon on the taskbar indicates that themobile computer is connected to a network.How to ConnectConnect the Ethernet dock (Ethernet port 1 - D) to an Ethernethub or to a port on the host device. Connect the Ethernet dock(power port - B) to the power supply.NoteThe user is responsible for any damages caused byincorrect use of the equipment or by inobservanceof the indication supplied in this manual.NoteDo not attempt to disassemble the Multi-slotEthernet Dock, as it does not contain parts that canbe repaired by the user. Any tampering willinvalidate the warranty.A. Power LED C. Ethernet Port 1B. Power Port D. Ethernet Port 2COLOR STATUS 1Green Costant Dock Powered 2NOTEThe maximum bandwidth capacity for each MobileComputer is 12Mbps.CAUTIONConnections should always be made with powerOFF!A. Multi-slot Dock Ethernet D. Ethernet Port 1B. Power Port E. UTP CAT 5E cable(recommended use)C. Power supply (power cordto be ordered separately)F. Ethernet hub